EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Few-Layered Black Phosphorene as Hole Transport Layer for Novel All-Inorganic Perovskite Solar Cells

Shihui Xu, Lin Yang, Zhe Wang, Fuyun Li, Xiaoping Zhang iD, Juan Zhou, Dongdong Lv, Yunfeng Ding, Wei Sun iD

Materials · 17.01.2025 · 18 (2) · 415

DOI: 10.3390/ma18020415 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 17.01.2025. Verfasst von Shihui Xu und 8 weiteren Autor:innen. Beteiligte Einrichtung: Hainan Engineering Research Center of Tropical Ocean Advanced Optoelectronic Functional Materials, Hainan International Joint Research Center of Mari…. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Hainan Provincial Natural Science Foundation of High Level-talent Project, the National Natural Science Foundation of China, Open Foundation of Engineering Research Center of Environment-Friendly Functional Materi-als, Ministry of Education.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The CsPbBr3 perovskite exhibits strong environmental stability under light, humidity, temperature, and oxygen conditions. However, in all-inorganic perovskite solar cells (PSCs), interface defects between the carbon electrode and CsPbBr3 limit the carrier separation and transfer rates. We used black phosphorus (BP) nanosheets as the hole transport layer (HTL) to construct an all-inorganic carbon-based CsPbBr3 perovskite (FTO/c-TiO2/m-TiO2/CsPbBr3/BP/C) solar cell. BP can enhance hole extraction capabilities and reduce carrier recombination by adjusting the interface contact between the perovskite and the carbon layer. Due to the coordination of the energy structure related to interface charge extraction and transfer, BP, as a new type of hole transport layer for all-inorganic CsPbBr3 solar cells, achieves a power conversion efficiency (PCE) that is 1.43% higher than that of all-inorganic carbon-based CsPbBr3 perovskite solar cells without a hole transport layer, reaching 2.7% (Voc = 1.29 V, Jsc = 4.60 mA/cm2, FF = 48.58%). In contrast, the PCE of the all-inorganic carbon-based CsPbBr3 perovskite solar cells without a hole transport layer was only 1.27% (Voc = 1.22 V, Jsc = 2.65 mA/cm2, FF = 39.51%). The unencapsulated BP-based PSCs device maintained 69% of its initial efficiency after being placed in the air for 500 h. In contrast, the efficiency of the PSC without HTL significantly decreased to only 52% of its initial efficiency. This indicates that BP can effectively enhance the PCE and stability of PSCs, demonstrating its great potential as a hole transport material in all-inorganic perovskite solar cells. BP as the HTL for CsPbBr3 PSCs can passivate the perovskite interface, enhance the hole extraction capability, and improve the optoelectronic performance of the device. The subsequent doping and compounding of the BP hole transport layer can further enhance its photovoltaic conversion efficiency in PSCs.

Schlagwörter

Stichwörter der Autor:innen

CsPbBr3black phosphorushole transport layerperovskitesolar cells

Autor:innen und Institutionen

  • Hainan Engineering Research Center of Tropical Ocean Advanced Optoelectronic Functional Materials, Hainan International Joint Research Center of Marine Advanced Photoelectric Functional Materials, Key Laboratory of Lase…
  • Engineering Research Center of Environmentally-Friendly Functional Materials, Ministry of Education, Huaqiao University, Xiamen 361021, China.
  • College of Physics and Electronic Engineering, Hainan Normal University, Haikou 571158, China.

ORCID-Profile: Xiaoping Zhang, Wei Sun

Förderung

  • Hainan Provincial Natural Science Foundation of High Level-talent Project
  • the National Natural Science Foundation of China
  • Open Foundation of Engineering Research Center of Environment-Friendly Functional Materi-als, Ministry of Education
  • Open Foundation of Engineering Research Center of Environment-Friendly Functional Materials, Ministry of Education

Zitieren

APA

Xu, S., Yang, L., Wang, Z., Li, F., Zhang, X., Zhou, J., Lv, D., Ding, Y., & Sun, W. (2025). Few-Layered Black Phosphorene as Hole Transport Layer for Novel All-Inorganic Perovskite Solar Cells. Materials, 18(2), 415. https://doi.org/10.3390/ma18020415

Vancouver

Xu S, Yang L, Wang Z, Li F, Zhang X, Zhou J, et al. Few-Layered Black Phosphorene as Hole Transport Layer for Novel All-Inorganic Perovskite Solar Cells. Materials. 2025;18(2):415. doi:10.3390/ma18020415

BibTeX
@article{Xu2025,
  author = {Xu, Shihui and Yang, Lin and Wang, Zhe and Li, Fuyun and Zhang, Xiaoping and Zhou, Juan and Lv, Dongdong and Ding, Yunfeng and Sun, Wei},
  title = {Few-Layered Black Phosphorene as Hole Transport Layer for Novel All-Inorganic Perovskite Solar Cells},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {2},
  pages = {415},
  doi = {10.3390/ma18020415}
}
Kostenlos starten →