EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A Study on the Bending Stiffness of Reinforced Concrete Tunnel Segments with Added Steel Fibers

Fan Zhang iD, Wouter De Corte iD, Luc Taerwe, Weibiao Cao, Xian Liu

Materials · 26.12.2024 · 18 (1) · 48

DOI: 10.3390/ma18010048 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 26.12.2024. Verfasst von Fan Zhang und 4 weiteren Autor:innen. Beteiligte Einrichtung: College of Civil Engineering, Tongji University, Shanghai 200092, China. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In recent years, steel-fiber-reinforced concrete (SFRC) has been increasingly applied in shield tunnel engineering. However, most research on SFRC segments focuses on the load-bearing capacity, while the tunnel deformation is an equally critical indicator that decides if the tunnel can operate safely during service conditions. Therefore, it is essential to also study the stiffness variations in SFRC segments, which is closely connected to the serviceability limit state (SLS). To investigate the influence of SFRC on segment stiffness, full-scale four-point bending tests and analytical calculations are carried out on both traditional reinforced concrete (RC) segments and SFRC segments with rebars. A C55 plain concrete is used in the RC segment, and for SFRC, 30 kg/m3 steel fibers are added. The segment stiffnesses are calculated and analyzed, and compared between test and analytical results. This study shows that the addition of steel fibers to traditional reinforced concrete segments can enhance the bending stiffness. This effect becomes apparent only after the segments crack. Initially, the effect is strong but then becomes weaker, with increasing load. The added 30 kg/m3 steel fibers generate a maximum of 33% in stiffness increment for a segment with 2.1% reinforcement. Further analysis indicates that the transfer of stresses in the cracked SFRC results in a stiffness improvement, but after cracking, the contribution of the reinforcement to the flexural resistance increases while the contribution of the SFRC gradually decreases. Thus, the effect is weak at high load levels. This paper contributes to a better understanding of the effect of SFRC on the stiffness of segments, as relevant for SLS requirements.

Schlagwörter

Stichwörter der Autor:innen

analytical modelfull-scale testssegment stiffnesssteel-fiber-reinforced concretetunnel segments

Autor:innen und Institutionen

  • College of Civil Engineering, Tongji University, Shanghai 200092, China.
  • Department of Structural Engineering and Building Materials, Ghent University, 9052 Ghent, Belgium.
  • Shanghai Tunnel Engineering and Rail Transit Design & Research Institute, Shanghai 200235, China.
  • State Key Laboratory for Hazard Reduction in Civil Engineering, Tongji University, Shanghai 200092, China.

ORCID-Profile: Fan Zhang, Wouter De Corte

Zitieren

APA

Zhang, F., De Corte, W., Taerwe, L., Cao, W., & Liu, X. (2024). A Study on the Bending Stiffness of Reinforced Concrete Tunnel Segments with Added Steel Fibers. Materials, 18(1), 48. https://doi.org/10.3390/ma18010048

Vancouver

Zhang F, De Corte W, Taerwe L, Cao W, Liu X. A Study on the Bending Stiffness of Reinforced Concrete Tunnel Segments with Added Steel Fibers. Materials. 2024;18(1):48. doi:10.3390/ma18010048

BibTeX
@article{Zhang2024,
  author = {Zhang, Fan and De Corte, Wouter and Taerwe, Luc and Cao, Weibiao and Liu, Xian},
  title = {A Study on the Bending Stiffness of Reinforced Concrete Tunnel Segments with Added Steel Fibers},
  journal = {Materials},
  year = {2024},
  volume = {18},
  number = {1},
  pages = {48},
  doi = {10.3390/ma18010048}
}
Kostenlos starten →