EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Gradient Titanium Alloy with Bioactive Hydroxyapatite Porous Structures for Potential Biomedical Applications

Julia Sadlik, Edyta Kosińska, Magdalena Bańkosz, Agnieszka Tomala iD, Grzegorz Bruzda iD, Josef Jampilek iD, Agnieszka Sobczak-Kupiec iD

Materials · 12.11.2024 · 17 (22) · 5511

DOI: 10.3390/ma17225511 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 12.11.2024. Verfasst von Julia Sadlik und 6 weiteren Autor:innen. Beteiligte Einrichtung: Cracow University of Technology, CUT Doctoral School, Faculty of Materials Engineering and Physics, Department of Materials Science, Faculty of Mater…. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Slovak Research and Development Agency, National Centre for Research and Development.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hard bone disease is a clinical problem affecting more than 20 million people annually worldwide, with significant health, social, and economic consequences. For successful integration of any implant, the key aspects are bone regeneration, osseointegration at the bone–implant interface, and the mitigation of inflammation. The purpose of this research work is to demonstrate an innovative material system and method of biomaterial preparation for regenerative medicine. A number of studies were carried out for both hydroxyapatite powder and composites. Wet-precipitated synthesized hydroxyapatite was compared to commercial products through accurate physicochemical studies that confirmed the high purity of the obtained calcium phosphate without any impurities. Ti/HAp composites before and after sintering were compared by XRF, XRD, SEM, EDS, PSA, and roughness measurements, and the Vickers microhardness was analyzed. The fabrication of the biomaterial was based on a bottom-up approach, which involved fabricating HAp particles with specific morphologies using powder metallurgy (PM) to sinter Ti composites. The resulting gradient structures consisting of two compositions (5%HAp%5CMC and 10%HAp10%CMC) mimic the structure of bone tissue. The created pores of 10–100 µm in size will allow bone cells to penetrate the implant and regenerate bone. In turn, the introduction of hydroxyapatite into the material reduces the microhardness of the composite and introduces properties such as bioactivity. The developed composite material contains a combination of Ti alloy and hydroxyapatite (HAp), creating an excellent biomaterial that promotes bone growth and eliminates the problem of implant loosening by integrating it into the bone. This material requires further research, especially biological research. However, it shows promising potential for further experiments.

Schlagwörter

Stichwörter der Autor:innen

Ti6Al4Vbiomaterialshydroxyapatiteporous materialstitanium alloys

Autor:innen und Institutionen

  • Cracow University of Technology, CUT Doctoral School, Faculty of Materials Engineering and Physics, Department of Materials Science, Faculty of Materials Engineering and Physics, Cracow University of Technology, 37 Jana…
  • Cracow University of Technology, Faculty of Materials Engineering and Physics, Department of Materials Science, 37 Jana Pawła II Av., 31-864 Krakow, Poland.
  • Łukasiewicz Research Network-Krakow Institute of Technology, Zakopiańska 73 Str., 30-418 Krakow, Poland.
  • Department of Analytical Chemistry, Faculty of Natural Sciences, Comenius University, Ilkovicova 6, 842 15 Bratislava, Slovakia.
  • Department of Chemical Biology, Faculty of Science, Palacky University Olomouc, Slechtitelu 27, 783 71 Olomouc, Czech Republic.

ORCID-Profile: Agnieszka Tomala, Grzegorz Bruzda, Josef Jampilek, Agnieszka Sobczak-Kupiec

Förderung

  • Slovak Research and Development Agency
  • National Centre for Research and Development

Zitieren

APA

Sadlik, J., Kosińska, E., Bańkosz, M., Tomala, A., Bruzda, G., Jampilek, J., & Sobczak-Kupiec, A. (2024). Gradient Titanium Alloy with Bioactive Hydroxyapatite Porous Structures for Potential Biomedical Applications. Materials, 17(22), 5511. https://doi.org/10.3390/ma17225511

Vancouver

Sadlik J, Kosińska E, Bańkosz M, Tomala A, Bruzda G, Jampilek J, et al. Gradient Titanium Alloy with Bioactive Hydroxyapatite Porous Structures for Potential Biomedical Applications. Materials. 2024;17(22):5511. doi:10.3390/ma17225511

BibTeX
@article{Sadlik2024,
  author = {Sadlik, Julia and Kosińska, Edyta and Bańkosz, Magdalena and Tomala, Agnieszka and Bruzda, Grzegorz and Jampilek, Josef and Sobczak-Kupiec, Agnieszka},
  title = {Gradient Titanium Alloy with Bioactive Hydroxyapatite Porous Structures for Potential Biomedical Applications},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {22},
  pages = {5511},
  doi = {10.3390/ma17225511}
}
Kostenlos starten →