EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Chloride Corrosion Process of Concrete with Different Water–Binder Ratios under Variable Temperature Drying–Wetting Cycles

Lei Wang, Chunhong Chen, Ronggui Liu, Pinghua Zhu, Hui Liu iD, Hongwei Jiang iD, Jiang Yu

Materials · 11.05.2024 · 17 (10) · 2263

DOI: 10.3390/ma17102263 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 11.05.2024. Verfasst von Lei Wang und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Urban Construction, Changzhou University, Changzhou 213164, China. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this paper, four water–binder ratios (w/b) of 0.29, 0.33, 0.39, and 0.46 were designed. A variable test temperature was implemented in the drying–wetting cycle test according to the temperature fluctuations in the actual service environment, and the constant temperature test was established as the control group. The mechanical properties and chloride corrosion resistance of concrete with different w/b ratios under variable temperature drying–wetting cycles, as well as the microstructure changes, phase composition, and damage mechanism inside the concrete, were investigated. The results showed that the mechanical properties of concrete increased first and then decreased with drying–wetting cycles increasing, whereas the chloride corrosion resistance continued to decline. A higher w/b exacerbated the deterioration of the concrete performance. A higher w/b increased the porosity, chloride diffusion depth, and chloride content, thus reducing the resistance of chloride corrosion. Compared with w/b = 0.29, the compressive strength, splitting tensile strength, mass, and relative dynamic elasticity modulus of w/b = 0.46 exposed to 60 drying–wetting cycles decreased by 54.50%, 52.44%, 0.96%, and 6.50%, respectively, while the porosity, peak chloride content, and erosion depth increased by 45.12%, 70.45%, and 45.00%. Compared with the drying–wetting cycle with a constant temperature, the cumulative damage caused by the drying–wetting cycle with a variable temperature was greater, resulting in more severe deterioration of concrete performance. The increase in the test temperature significantly accelerated the diffusion rate, penetration depth, and chemical binding capacity of chloride ions. After 60 drying–wetting cycles, the peak chlorine content and erosion depth of w/b = 0.46 under variable temperature cycles were 15.38% and 10.32% higher than those under a constant temperature, while the compressive strength, splitting tensile strength, mass, and relative dynamic elastic modulus were reduced by 7.76%, 14.81%, 0.33%, and 2.40%, respectively. Microscopic analysis confirmed that higher w/b and variable temperature cycles accelerated the decay of mechanical properties and the decline of chloride corrosion resistance. According to the numerical fitting analysis, the w/b should be 0.29~0.39 under the condition that the mechanical properties and chloride corrosion resistance of concrete are met.

Schlagwörter

Stichwörter der Autor:innen

drying–wetting cycleserosion depthfree chloride contentmechanical propertiesvariable temperaturewater–binder ratio

Autor:innen und Institutionen

  • School of Urban Construction, Changzhou University, Changzhou 213164, China.
  • Faculty of Civil Engineering and Mechanics, Jiangsu University, Zhenjiang 212013, China.
  • State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan 430070, China.

ORCID-Profile: Hui Liu, Hongwei Jiang

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Wang, L., Chen, C., Liu, R., Zhu, P., Liu, H., Jiang, H., & Yu, J. (2024). Chloride Corrosion Process of Concrete with Different Water–Binder Ratios under Variable Temperature Drying–Wetting Cycles. Materials, 17(10), 2263. https://doi.org/10.3390/ma17102263

Vancouver

Wang L, Chen C, Liu R, Zhu P, Liu H, Jiang H, et al. Chloride Corrosion Process of Concrete with Different Water–Binder Ratios under Variable Temperature Drying–Wetting Cycles. Materials. 2024;17(10):2263. doi:10.3390/ma17102263

BibTeX
@article{Wang2024,
  author = {Wang, Lei and Chen, Chunhong and Liu, Ronggui and Zhu, Pinghua and Liu, Hui and Jiang, Hongwei and Yu, Jiang},
  title = {Chloride Corrosion Process of Concrete with Different Water–Binder Ratios under Variable Temperature Drying–Wetting Cycles},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {10},
  pages = {2263},
  doi = {10.3390/ma17102263}
}
Kostenlos starten →