EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Nitrogen Atmosphere Annealing of Alloyed Powders on the Microstructure and Properties of ODS Ferritic Steels

Agata Strojny-Nędza, Katarzyna Pietrzak, Iwona Jóźwik, Bartosz Bucholc iD, Edyta Wyszkowska iD, Łukasz Kurpaska iD, Agnieszka Grabias iD, Agnieszka Malinowska iD, Marcin Chmielewski

Materials · 10.04.2024 · 17 (8) · 1743

DOI: 10.3390/ma17081743 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 10.04.2024. Verfasst von Agata Strojny-Nędza und 8 weiteren Autor:innen. Beteiligte Einrichtung: Łukasiewicz Research Network Institute of Microelectronics and Photonics, 02-668 Warsaw, Poland. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 31 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Oxide Dispersion Strengthened (ODS) ferritic steels are promising materials for the nuclear power sector. This paper presents the results of a study on the sintering process using the Spark Plasma Sintering (SPS) technique, focusing on ODS ferritic steel powders with different contents (0.3 and 0.6 vol.%) of Y2O3. The novelty lies in the analysis of the effect of pre-annealing treatment on powders previously prepared by mechanical alloying on the microstructure, mechanical, and thermal properties of the sinters. Using the SPS method, it was possible to obtain well-densified sinters with a relative density above 98%. Pre-annealing the powders resulted in an increase in the relative density of the sinters and a slight increase in their thermal conductivity. The use of low electron energies during SEM analysis allowed for a fairly good visualization of the reinforcing oxides uniformly dispersed in the matrix. Analysis of the Mössbauer spectroscopy results revealed that pre-annealing induces local atomic rearrangements within the solid solution. In addition, there was an additional spectral component, indicating the formation of a Cr-based paramagnetic phase. The ODS material with a higher Y2O3 content showed increased Vickers hardness values, as well as increased Young’s modulus and nanohardness, as determined by nanoindentation tests.

Schlagwörter

Stichwörter der Autor:innen

Mössbauer spectroscopyODS ferritic steelmechanical alloyingnanoindentationspark plasma sintering

Autor:innen und Institutionen

  • Łukasiewicz Research Network Institute of Microelectronics and Photonics, 02-668 Warsaw, Poland.
  • Institute of Fundamental Technological Research, Polish Academy of Sciences, 02-106 Warsaw, Poland.
  • NOMATEN Centre for Excellence, National Centre for Nuclear Research, 05-400 Otwock, Poland.

ORCID-Profile: Bartosz Bucholc, Edyta Wyszkowska, Łukasz Kurpaska, Agnieszka Grabias, Agnieszka Malinowska

Zitieren

APA

Strojny-Nędza, A., Pietrzak, K., Jóźwik, I., Bucholc, B., Wyszkowska, E., Kurpaska, Ł., Grabias, A., Malinowska, A., & Chmielewski, M. (2024). Effect of Nitrogen Atmosphere Annealing of Alloyed Powders on the Microstructure and Properties of ODS Ferritic Steels. Materials, 17(8), 1743. https://doi.org/10.3390/ma17081743

Vancouver

Strojny-Nędza A, Pietrzak K, Jóźwik I, Bucholc B, Wyszkowska E, Kurpaska Ł, et al. Effect of Nitrogen Atmosphere Annealing of Alloyed Powders on the Microstructure and Properties of ODS Ferritic Steels. Materials. 2024;17(8):1743. doi:10.3390/ma17081743

BibTeX
@article{StrojnyNdza2024,
  author = {Strojny-Nędza, Agata and Pietrzak, Katarzyna and Jóźwik, Iwona and Bucholc, Bartosz and Wyszkowska, Edyta and Kurpaska, Łukasz and Grabias, Agnieszka and Malinowska, Agnieszka and Chmielewski, Marcin},
  title = {Effect of Nitrogen Atmosphere Annealing of Alloyed Powders on the Microstructure and Properties of ODS Ferritic Steels},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {8},
  pages = {1743},
  doi = {10.3390/ma17081743}
}
Kostenlos starten →