Zn-Based Alloys for Plain Bearings—Influence of Al and Cu Content on Mechanical Properties
Materials · 26.02.2024 · 17 (5) · 1062
DOI: 10.3390/ma17051062 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 26.02.2024. Verfasst von Angelika Kiefel und 3 weiteren Autor:innen. Beteiligte Einrichtung: Institute for Materials Applications in Mechanical Engineering, 52062 Aachen, Germany. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Federal Ministry for Economic Affairs and Climate Action.
Abstract (Originalsprache)
In recent decades, the requirements for plain bearing materials have continually increased, especially with new applications such as wind turbines, which require larger bearings. These new applications have completely different property profiles compared with, for example, bearings in automotive construction. Larger bearings need high strength and wear resistance, which established bearing materials cannot fulfill. Therefore, new alloy systems are required. This publication focuses on the influence of alloy composition and test temperature on the mechanical properties of ZnAlCu alloys. Centrifugally cast specimens were produced for the fabrication of test specimens, which were used to determine the mechanical and tribological properties. Fracture surface and wear trace analysis with scanning electron and light microscopy were used to determine occurring failure and wear mechanisms and to analyze the influence of microstructure on failure. Depending on the composition of the ZnAlCu alloys, up to three times higher strengths can be achieved compared with the white metal alloy SnSb12Cu6ZnAg. Furthermore, all the alloys investigated show good wear properties. Up to 11 wt.% aluminum and 1.5 wt.% copper, a significant decrease in the wear coefficient was observed. Knowledge about the correlation between microstructure, properties, and failure mechanisms of ZnAlCu alloys can be used to produce bearing metal alloys suitable for a wide range of applications. Since the strength values lie between those of white metals and bronze, new fields of application can also be accessed.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Institute for Materials Applications in Mechanical Engineering, 52062 Aachen, Germany.
- Foundry Institute, RWTH Aachen University, 52072 Aachen, Germany.
Förderung
- Federal Ministry for Economic Affairs and Climate Action
Zitieren
APA
Kiefel, A., Gimmler, S., Broeckmann, C., & Vroomen, U. (2024). Zn-Based Alloys for Plain Bearings—Influence of Al and Cu Content on Mechanical Properties. Materials, 17(5), 1062. https://doi.org/10.3390/ma17051062
Vancouver
Kiefel A, Gimmler S, Broeckmann C, Vroomen U. Zn-Based Alloys for Plain Bearings—Influence of Al and Cu Content on Mechanical Properties. Materials. 2024;17(5):1062. doi:10.3390/ma17051062
BibTeX
@article{Kiefel2024,
author = {Kiefel, Angelika and Gimmler, Steffen and Broeckmann, Christoph and Vroomen, Uwe},
title = {Zn-Based Alloys for Plain Bearings—Influence of Al and Cu Content on Mechanical Properties},
journal = {Materials},
year = {2024},
volume = {17},
number = {5},
pages = {1062},
doi = {10.3390/ma17051062}
}
EUVIMED