Eco-Friendly Pavements Manufactured from Mixed Recycled Aggregates Obtained from Construction and Demolition Waste: An Industrial-Scale Validation
Materials · 07.12.2023 · 16 (24) · 7544
DOI: 10.3390/ma16247544 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 07.12.2023. Verfasst von Manuel Contreras-Llanes und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Sociology, Social Work and Public Health, Research Centre for Natural Resources, Health and Environment (RENSMA), University of Huelva,…. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 76 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Centre for the Development of Industrial Technology (CDTI), the project “Eco-efficient concrete urban paving from mixed recycled aggregates obtained from CDW”, the Spanish Ministry of Science, Innovation and Universities’ Research Agency.
Abstract (Originalsprache)
This study aimed to validate that laboratory-scale results could be commercially replicated when manufacturing marketable precast concrete. Construction and demolition waste (CDW) was separated into two (fine and coarse) recycled aggregates (RAs). Precast paver and kerb units were fabricated by partial or total substitution of natural aggregates (NAs) by RAs. The study involved the comprehensive characterisation of raw materials, including particle size distribution, mineral composition, and elemental composition. Paver blocks and kerbs manufactured with up to 50% RAs showed mechanical resistance (T = 3.7 ± 0.2 and B = 5.3 ± 0.6 MPa, respectively), water absorption between 5.3–5.7%, and abrasion resistance (approximately 20.2 mm), which met the standard requirements (UNE-EN 1340:2004 and UNE-EN 1338:2004). Furthermore, industrial-scale precast pavement units demonstrated strength and durability suitable for heavy traffic areas. A reduction of 13% in cement content could maintain the requirements with a partial RA substitution of 25%, offering economic and environmental benefits. Therefore, it is feasible at an industrial level to replace NAs with RAs, promoting durability and technological properties with a positive environmental impact and considerably reducing CO2 emissions by up to 65%. Overall, pavers with RAs manufactured at the laboratory scale met mechanical standards, and the kerb stones showed improvements in abrasion resistance. On an industrial scale, kerb stones and precast blocks with specific substitutions can meet strength, water absorption, and abrasion requirements, allowing a reduction in cement content.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Sociology, Social Work and Public Health, Research Centre for Natural Resources, Health and Environment (RENSMA), University of Huelva, 21007 Huelva, Spain.
- Department of Applied Physics, Marine Research Institute (INMAR), University of Cádiz, 11510 Cádiz, Spain.
- Department of Materials, Eduardo Torroja Institute for Construction Sciences (IETcc-CSIC), 28033 Madrid, Spain.
ORCID-Profile: Manuel Contreras-Llanes, Manuel Jesús Gázquez, Maximina Romero
Förderung
- the Centre for the Development of Industrial Technology (CDTI)
- the project “Eco-efficient concrete urban paving from mixed recycled aggregates obtained from CDW”
- the Spanish Ministry of Science, Innovation and Universities’ Research Agency
Zitieren
APA
Contreras-Llanes, M., Gázquez, M. J., & Romero, M. (2023). Eco-Friendly Pavements Manufactured from Mixed Recycled Aggregates Obtained from Construction and Demolition Waste: An Industrial-Scale Validation. Materials, 16(24), 7544. https://doi.org/10.3390/ma16247544
Vancouver
Contreras-Llanes M, Gázquez MJ, Romero M. Eco-Friendly Pavements Manufactured from Mixed Recycled Aggregates Obtained from Construction and Demolition Waste: An Industrial-Scale Validation. Materials. 2023;16(24):7544. doi:10.3390/ma16247544
BibTeX
@article{ContrerasLlanes2023,
author = {Contreras-Llanes, Manuel and Gázquez, Manuel Jesús and Romero, Maximina},
title = {Eco-Friendly Pavements Manufactured from Mixed Recycled Aggregates Obtained from Construction and Demolition Waste: An Industrial-Scale Validation},
journal = {Materials},
year = {2023},
volume = {16},
number = {24},
pages = {7544},
doi = {10.3390/ma16247544}
}
EUVIMED