EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Synthesis and Luminescent Properties of Barium Molybdate Nanoparticles

Maria Gancheva, Reni Iordanova iD, Iovka Koseva, Georgi Avdeev iD, Gergana Burdina, Petar Ivanov

Materials · 03.11.2023 · 16 (21) · 7025

DOI: 10.3390/ma16217025 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 03.11.2023. Verfasst von Maria Gancheva und 5 weiteren Autor:innen. Beteiligte Einrichtung: Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, "Acad. G. Bonchev" Str., bl. 11, 1113 Sofia, Bulgaria. Die Arbeit wurde bisher 18-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Education and Science, European Network on Materials for Clean Technologies.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

BaMoO4 was obtained via facile mechanochemical synthesis at room temperature and a solid-state reaction. An evaluation of the phase composition and structural and optical properties of BaMoO4 was conducted. The influence of different milling speeds on the preparation of BaMoO4 was explored. A shorter reaction time for the phase formation of BaMoO4 was achieved using a milling speed of 850 rpm. A milling speed of 500 rpm led to partial amorphization of the initial reagents and to prolongation of the synthesis time of up to 3 h of milling time. Solid-state synthesis was performed via heat treatment at 900 °C for 15 h. X-ray diffraction analysis (XRD), infrared (IR) and UV diffuse reflectance (UV-Vis) and photoluminescence (PL) spectroscopy were carried out to characterize the samples. Independently of the method of preparation, the obtained samples had tetragonal symmetry. The average crystallite sizes of all samples, calculated using Scherrer’s formula, were in the range of 240 to 1540 Å. IR spectroscopy showed that more distorted structural MoO4 units were formed when the compound was synthesized via a solid-state reaction. The optical band gap energy of the obtained materials was found to decrease from 4.50 to 4.30 eV with increasing crystallite sizes. Green- and blue-light emissions were observed for BaMoO4 phases under excitation wavelengths of 330 and 488 nm. It was established that the intensity of the PL peaks depends on two factors: the symmetry of MoO4 units and the crystallite sizes.

Schlagwörter

Stichwörter der Autor:innen

BaMoO4blue and green photoluminescencecolor coordinateshigh-energy ball millinginfrared absorption bandsnanoparticlesoptical band gapssolid-state reaction

Autor:innen und Institutionen

  • Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, "Acad. G. Bonchev" Str., bl. 11, 1113 Sofia, Bulgaria.
  • Institute of Physical Chemistry "Acad. Rostislaw Kaischew", Bulgarian Academy of Sciences, "Acad. G. Bonchev" Str., bl. 11, 1113 Sofia, Bulgaria.
  • Institute of Optical Materials and Technologies "Acad. Jordan Malinowski", Bulgarian Academy of Sciences, "Acad. G. Bonchev" Str., bl. 109, 1113 Sofia, Bulgaria.

ORCID-Profile: Reni Iordanova, Georgi Avdeev

Förderung

  • Ministry of Education and Science
  • European Network on Materials for Clean Technologies

Zitieren

APA

Gancheva, M., Iordanova, R., Koseva, I., Avdeev, G., Burdina, G., & Ivanov, P. (2023). Synthesis and Luminescent Properties of Barium Molybdate Nanoparticles. Materials, 16(21), 7025. https://doi.org/10.3390/ma16217025

Vancouver

Gancheva M, Iordanova R, Koseva I, Avdeev G, Burdina G, Ivanov P. Synthesis and Luminescent Properties of Barium Molybdate Nanoparticles. Materials. 2023;16(21):7025. doi:10.3390/ma16217025

BibTeX
@article{Gancheva2023,
  author = {Gancheva, Maria and Iordanova, Reni and Koseva, Iovka and Avdeev, Georgi and Burdina, Gergana and Ivanov, Petar},
  title = {Synthesis and Luminescent Properties of Barium Molybdate Nanoparticles},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {21},
  pages = {7025},
  doi = {10.3390/ma16217025}
}
Kostenlos starten →