EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effects of Oxygen Flow during Fabrication by Magnetron Sputtering on Structure and Performance of Zr-Doped HfO2 Thin Films

Yingxue Xi iD, Lei Liu, Jiwu Zhao iD, Xinhui Qin, Jin Zhang iD, Changming Zhang, Weiguo Liu iD

Materials · 10.08.2023 · 16 (16) · 5559

DOI: 10.3390/ma16165559 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 10.08.2023. Verfasst von Yingxue Xi und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Optoelectronic Engineering, Xi'an Technological University, Xi'an 710021, China. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Oxygen defects in Hafnium Oxide (HfO2)-based ferroelectric thin films not only are related to the cause of ferroelectricity but also affect the ferroelectric properties of the thin films. This paper, therefore, focuses on the fabrication of Zr:HfO2 thin films by RF (Radio Frequency) magnetron sputtering with Zr-doped HfO2 as the target and examines how oxygen flow impacts the oxygen vacancies and electrical properties thereof. Additionally, TiN thin-film electrodes were prepared by direct current (DC) magnetron reactive sputtering using nitrogen as the reaction gas, the influences of the substrate temperature on the film deposition rate and crystal phase structure were investigated, and the resultant thin-film electrodes with the lowest resistivity were obtained. Furthermore, the ferroelectric hysteresis loop and leakage current density of metal–insulator–metal (MIM) ferroelectric capacitors formed by annealing the 30 nm thick deposited Zr:HfO2 sandwiched between the top and bottom TiN electrodes were measured. The results demonstrate that varying oxygen flow has a considerable effect on oxygen vacancies and the Zr doping concentration of deposited Zr:HfO2 ferroelectric thin films. When the oxygen flow is set to 40 sccm (standard cubic centimeters per minute) and an external electric field strength of 2 mV/cm is applied, the remnant polarization reaches 18 μC/cm2, with a decrease in the leakage current density of 105–6 orders of magnitude.

Schlagwörter

Stichwörter der Autor:innen

Zr-dopedferroelectric thin filmhafnium oxide-based heterojunctionmagnetron sputteringoxygen mass flux

Autor:innen und Institutionen

  • School of Optoelectronic Engineering, Xi'an Technological University, Xi'an 710021, China.

ORCID-Profile: Yingxue Xi, Jiwu Zhao, Jin Zhang, Weiguo Liu

Zitieren

APA

Xi, Y., Liu, L., Zhao, J., Qin, X., Zhang, J., Zhang, C., & Liu, W. (2023). Effects of Oxygen Flow during Fabrication by Magnetron Sputtering on Structure and Performance of Zr-Doped HfO2 Thin Films. Materials, 16(16), 5559. https://doi.org/10.3390/ma16165559

Vancouver

Xi Y, Liu L, Zhao J, Qin X, Zhang J, Zhang C, et al. Effects of Oxygen Flow during Fabrication by Magnetron Sputtering on Structure and Performance of Zr-Doped HfO2 Thin Films. Materials. 2023;16(16):5559. doi:10.3390/ma16165559

BibTeX
@article{Xi2023,
  author = {Xi, Yingxue and Liu, Lei and Zhao, Jiwu and Qin, Xinhui and Zhang, Jin and Zhang, Changming and Liu, Weiguo},
  title = {Effects of Oxygen Flow during Fabrication by Magnetron Sputtering on Structure and Performance of Zr-Doped HfO2 Thin Films},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {16},
  pages = {5559},
  doi = {10.3390/ma16165559}
}
Kostenlos starten →