EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Possibilities of Checking Water Content in Porous Geopolymer Materials Using Impedance Spectroscopy Methods

Dariusz Mierzwiński iD, Janusz Walter iD, Dominika Wanat

Materials · 24.07.2023 · 16 (14) · 5190

DOI: 10.3390/ma16145190 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 24.07.2023. Verfasst von Dariusz Mierzwiński und 2 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Materials Engineering and Physics, Cracow University of Technology, 24 Warszawska Street, 31-155 Kraków, Poland. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The porous geopolymer has been tested for its content of water using impedance methods. The pores of the material were filled with distilled water using a desiccator and a vacuum pump. An analysis of differential scanning calorimetry (DSC) was carried out in the next step to check the content of water, porosity and approximate value of specific heat of the geopolymer. Additionally, mercury porosimeter has been used for checking the porosity. The geopolymer material characterized in this way was subjected to impedance tests aimed at developing a quick method for assessing the water content in the material. Impedance measurements have been realized on an electrochemical workstation applying a 50 mV non-destructive amplitude of the potential and a frequency range of 1 Hz to 100 kHz. Change in the module of impedance and the phase shift angle were measured while the material was dried out. Significant differences were observed. The obtained graphs were simulated using a schematic model consisting of constant phase elements (CPEs) and a resistor (R). These values showed mechanisms of charge conduction. A simple method for assessing the water content of a porous geopolymer has been proposed in this paper. The real and imaginary impedance values were shown in Nyquist graphs. These graphs have characteristic maxima that move according to a linear equation with decreasing water content. Changes in Nyqiust charts are clearly visible even with small changes in the water content of the material and can be very useful for assessing it.

Schlagwörter

Stichwörter der Autor:innen

Bode plotsNyquist plotsgeopolymerimpedance measurementsporosityporous material

Autor:innen und Institutionen

  • Faculty of Materials Engineering and Physics, Cracow University of Technology, 24 Warszawska Street, 31-155 Kraków, Poland.

ORCID-Profile: Dariusz Mierzwiński, Janusz Walter

Zitieren

APA

Mierzwiński, D., Walter, J., & Wanat, D. (2023). Possibilities of Checking Water Content in Porous Geopolymer Materials Using Impedance Spectroscopy Methods. Materials, 16(14), 5190. https://doi.org/10.3390/ma16145190

Vancouver

Mierzwiński D, Walter J, Wanat D. Possibilities of Checking Water Content in Porous Geopolymer Materials Using Impedance Spectroscopy Methods. Materials. 2023;16(14):5190. doi:10.3390/ma16145190

BibTeX
@article{Mierzwiski2023,
  author = {Mierzwiński, Dariusz and Walter, Janusz and Wanat, Dominika},
  title = {Possibilities of Checking Water Content in Porous Geopolymer Materials Using Impedance Spectroscopy Methods},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {14},
  pages = {5190},
  doi = {10.3390/ma16145190}
}
Kostenlos starten →