EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Tension Stiffening and Cracking Behavior of Axially Loaded Alkali-Activated Concrete

Hamdi Abdulrahman iD, Rahimah Muhamad, Ahmad Azim Shukri, Amin Al-Fakih iD, Gamal Alqaifi, Ayad Mutafi, Husam S Al-Duais iD, Abdulnaser M Al-Sabaeei iD

Materials · 31.05.2023 · 16 (11) · 4120

DOI: 10.3390/ma16114120 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 31.05.2023. Verfasst von Hamdi Abdulrahman und 7 weiteren Autor:innen. Beteiligte Einrichtung: Razak Faculty of Technology and Informatics, Universiti Teknologi Malaysia, Kuala Lumpur 54100, Malaysia. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: University of Technology Malaysia, Universiti Teknologi Malaysia.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Alkali-activated concrete is an eco-friendly construction material that is used to preserve natural resources and promote sustainability in the construction industry. This emerging concrete consists of fine and coarse aggregates and fly ash that constitute the binder when mixed with alkaline activators, such as sodium hydroxide (NaOH) and sodium silicate (Na2SiO3). However, understanding its tension stiffening and crack spacing and width is of critical importance in fulfilling serviceability requirements. Therefore, this research aims to evaluate the tension stiffening and cracking performance of alkali-activated (AA) concrete. The variables considered in this study were compressive strength (fc) and concrete cover-to-bar diameter (Cc/db) ratios. After casting the specimen, they were cured before testing at ambient curing conditions for 180 days to reduce the effects of concrete shrinkage and obtain more realistic cracking results. The results showed that both AA and OPC concrete prisms develop slightly similar axial cracking force and corresponding cracking strain, but OPC concrete prisms exhibited a brittle behavior, resulting in a sudden drop in the load–strain curves at the crack location. In contrast, AA concrete prisms developed more than one crack simultaneously, suggesting a more uniform tensile strength compared to OPC specimens. The tension-stiffening factor (β) of AA concrete exhibited better ductile behavior than OPC concrete due to the strain compatibility between concrete and steel even after crack ignition. It was also observed that increasing the confinement (Cc/db ratio) around the steel bar delays internal crack formation and enhances tension stiffening in AAC. Comparing the experimental crack spacing and width with the values predicted using OPC codes of practice, such as EC2 and ACI 224R, revealed that EC2 tends to underestimate the maximum crack width, while ACI 224R provided better predictions. Thus, models to predict crack spacing and width have been proposed accordingly.

Schlagwörter

Stichwörter der Autor:innen

OPC codes of practicealkali-activated concretecompressive strengthsconcrete crackingtension stiffening

Autor:innen und Institutionen

  • Razak Faculty of Technology and Informatics, Universiti Teknologi Malaysia, Kuala Lumpur 54100, Malaysia.
  • Faculty of Civil Engineering, Universiti Teknologi Malaysia, Johor Bahru 81310, Malaysia.
  • Interdisciplinary Research Center for Construction and Building Materials, King Fahd University of Petroleum and Minerals, Dhahran 31261, Saudi Arabia.
  • School of Built Environment, Faculty of Design, Architecture & Building, University of Technology Sydney, Ultimo, NSW 2007, Australia.
  • Jamilus Research Centre for Sustainable Construction (JRC-SC), Faculty of Civil Engineering and Built Environment, Universiti Tun Hussein Onn Malaysia, Parit Raja 86400, Malaysia.
  • Department of Architecture, Faculty of Built Environment, Universiti Malaya, Kuala Lumpur 50603, Malaysia.

ORCID-Profile: Hamdi Abdulrahman, Amin Al-Fakih, Husam S Al-Duais, Abdulnaser M Al-Sabaeei

Förderung

  • University of Technology Malaysia
  • Universiti Teknologi Malaysia

Zitieren

APA

Abdulrahman, H., Muhamad, R., Shukri, A. A., Al-Fakih, A., Alqaifi, G., Mutafi, A., Al-Duais, H. S., & Al-Sabaeei, A. M. (2023). Tension Stiffening and Cracking Behavior of Axially Loaded Alkali-Activated Concrete. Materials, 16(11), 4120. https://doi.org/10.3390/ma16114120

Vancouver

Abdulrahman H, Muhamad R, Shukri AA, Al-Fakih A, Alqaifi G, Mutafi A, et al. Tension Stiffening and Cracking Behavior of Axially Loaded Alkali-Activated Concrete. Materials. 2023;16(11):4120. doi:10.3390/ma16114120

BibTeX
@article{Abdulrahman2023,
  author = {Abdulrahman, Hamdi and Muhamad, Rahimah and Shukri, Ahmad Azim and Al-Fakih, Amin and Alqaifi, Gamal and Mutafi, Ayad and Al-Duais, Husam S and Al-Sabaeei, Abdulnaser M},
  title = {Tension Stiffening and Cracking Behavior of Axially Loaded Alkali-Activated Concrete},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {11},
  pages = {4120},
  doi = {10.3390/ma16114120}
}
Kostenlos starten →