Investigation of Tribological Characteristics of PEO Coatings Formed on Ti6Al4V Titanium Alloy in Electrolytes with Graphene Oxide Additives
Materials · 24.05.2023 · 16 (11) · 3928
DOI: 10.3390/ma16113928 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 24.05.2023. Verfasst von Sergey Grigoriev und 10 weiteren Autor:innen. Beteiligte Einrichtung: Spark Plasma Sintering Research Laboratory, Moscow State University of Technology "STANKIN", Vadkovsky per.1, Moscow 127055, Russia. Die Arbeit wurde bisher 48-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: The Ministry of Science and Higher Education of the Russian Federation.
Abstract (Originalsprache)
Coatings with a thickness from ~40 to ~50 µm on Ti6Al4V titanium alloys were formed by plasma electrolytic oxidation (PEO) in a silicate-hypophosphite electrolyte with the addition of graphene oxide. The PEO treatment was carried out in the anode–cathode mode (50 Hz) at a ratio of anode and cathode currents of 1:1; their sum density was 20 A/dm2, and the treatment’s duration was 30 min. The effect of the graphene oxide’s concentration in the electrolyte on the thickness, roughness, hardness, surface morphology, structure, composition, and tribological characteristics of the PEO coatings was studied. Wear experiments, under dry conditions, were carried out in a ball-on-disk tribotester with an applied load of 5 N, a sliding speed of 0.1 m·s−1, and a sliding distance of 1000 m. According to the obtained results, the addition of graphene oxide (GO) into the base silicate-hypophosphite electrolyte leads to a slight decrease in the coefficient of friction (from 0.73 to 0.69) and a reduction in the wear rate by more than 1.5 times (from 8.04 to 5.2 mm3/N·m), with an increase in the GO’s concentration from 0 to 0.5 kg/m3, respectively. This occurs due to the formation of a GO-containing lubricating tribolayer upon contact with the coating of the counter-body in the friction pair. Delamination of the coatings during wear occurs due to contact fatigue; with an increase in the concentration of GO in the electrolyte from 0 to 0.5 kg/m3, this process slows down by more than four times.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Spark Plasma Sintering Research Laboratory, Moscow State University of Technology "STANKIN", Vadkovsky per.1, Moscow 127055, Russia.
- Scientific Department, A.I. Evdokimov Moscow State University of Medicine and Dentistry, Delegatskaya St., 20, p.1, Moscow 127473, Russia.
- Department 1203, Moscow Aviation Institute, National Research University, Volokolamskoe Shosse, 4, Moscow 125993, Russia.
- Laboratory of Tribology, Ishlinsky Institute for Problems in Mechanics RAS, pr. Vernandskogo, 101-1, Moscow 119526, Russia.
ORCID-Profile: Sergey Grigoriev, Andrey Apelfeld, Anton Smirnov, Alexei Morozov, Pavel Peretyagin
Förderung
- The Ministry of Science and Higher Education of the Russian Federation
Zitieren
APA
Grigoriev, S., Peretyagin, N., Apelfeld, A., Smirnov, A., Morozov, A., Torskaya, E., Volosova, M., Yanushevich, O., Yarygin, N., Krikheli, N., & Peretyagin, P. (2023). Investigation of Tribological Characteristics of PEO Coatings Formed on Ti6Al4V Titanium Alloy in Electrolytes with Graphene Oxide Additives. Materials, 16(11), 3928. https://doi.org/10.3390/ma16113928
Vancouver
Grigoriev S, Peretyagin N, Apelfeld A, Smirnov A, Morozov A, Torskaya E, et al. Investigation of Tribological Characteristics of PEO Coatings Formed on Ti6Al4V Titanium Alloy in Electrolytes with Graphene Oxide Additives. Materials. 2023;16(11):3928. doi:10.3390/ma16113928
BibTeX
@article{Grigoriev2023,
author = {Grigoriev, Sergey and Peretyagin, Nikita and Apelfeld, Andrey and Smirnov, Anton and Morozov, Alexei and Torskaya, Elena and Volosova, Marina and Yanushevich, Oleg and Yarygin, Nikolay and Krikheli, Natella and Peretyagin, Pavel},
title = {Investigation of Tribological Characteristics of PEO Coatings Formed on Ti6Al4V Titanium Alloy in Electrolytes with Graphene Oxide Additives},
journal = {Materials},
year = {2023},
volume = {16},
number = {11},
pages = {3928},
doi = {10.3390/ma16113928}
}
EUVIMED