Surface Modification of Silicone by Dielectric Barrier Discharge Plasma
Materials · 08.04.2023 · 16 (8) · 2973
DOI: 10.3390/ma16082973 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 08.04.2023. Verfasst von Krzysztof Krawczyk und 5 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Chemistry, Warsaw University of Technology, ul. Noakowskiego 3, 00-664 Warsaw, Poland. Die Arbeit wurde bisher 14-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Warsaw University of Technology.
Abstract (Originalsprache)
The objective of the study was to modify the surface of the silicone rubber, using dielectric barrier discharge (DBD) to improve its hydrophilic properties. The influence of the exposure time, discharge power, and gas composition—in which the dielectric barrier discharge was generated—on the properties of the silicone surface layer were examined. After the modification, the wetting angles of the surface were measured. Then, the value of surface free energy (SFE) and changes in the polar components of the modified silicone over time were determined using the Owens–Wendt method. The surfaces and morphology of the selected samples before and after plasma modification were examined by Fourier-transform infrared spectroscopy with attenuated total reflectance (FTIR–ATR), atomic force microscopy AFM, and X-ray photoelectron spectroscopy (XPS). Based on the research, it can be concluded that the silicone surface can be modified using a dielectric barrier discharge. Surface modification, regardless of the chosen method, is not permanent. The AFM and XPS study show that the structure’s ratio of oxygen to carbon increases. However, after less than four weeks, it decreases and reaches the value of the unmodified silicone. It was found that the cause of the changes in the parameters of the modified silicone rubber is the disappearance of oxygen-containing groups on the surface and a decrease in the molar ratio of oxygen to carbon, causing the RMS surface roughness and the roughness factor to return to the initial values.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Faculty of Chemistry, Warsaw University of Technology, ul. Noakowskiego 3, 00-664 Warsaw, Poland.
- Institute of Physics, Polish Academy of Sciences, Al. Lotnikow 32/46, 02-664 Warsaw, Poland.
ORCID-Profile: Bogdan Ulejczyk, Tomasz Kobiela, Krystyna Ławniczak-Jabłońska
Förderung
- Warsaw University of Technology
Zitieren
APA
Krawczyk, K., Jankowska, A., Młotek, M., Ulejczyk, B., Kobiela, T., & Ławniczak-Jabłońska, K. (2023). Surface Modification of Silicone by Dielectric Barrier Discharge Plasma. Materials, 16(8), 2973. https://doi.org/10.3390/ma16082973
Vancouver
Krawczyk K, Jankowska A, Młotek M, Ulejczyk B, Kobiela T, Ławniczak-Jabłońska K. Surface Modification of Silicone by Dielectric Barrier Discharge Plasma. Materials. 2023;16(8):2973. doi:10.3390/ma16082973
BibTeX
@article{Krawczyk2023,
author = {Krawczyk, Krzysztof and Jankowska, Agnieszka and Młotek, Michał and Ulejczyk, Bogdan and Kobiela, Tomasz and Ławniczak-Jabłońska, Krystyna},
title = {Surface Modification of Silicone by Dielectric Barrier Discharge Plasma},
journal = {Materials},
year = {2023},
volume = {16},
number = {8},
pages = {2973},
doi = {10.3390/ma16082973}
}
EUVIMED