A Binary Salt Mixture LiCl–LiOH for Thermal Energy Storage
Materials · 08.02.2023 · 16 (4) · 1434
DOI: 10.3390/ma16041434 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 08.02.2023. Verfasst von Naveed Hassan und 4 weiteren Autor:innen. Beteiligte Einrichtung: Surface Analysis and Materials Engineering Research Group, College of Science, Health, Engineering and Education, Murdoch University, Perth, WA 6150,…. Die Arbeit wurde bisher 24-mal zitiert (Crossref) und nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
For thermal energy storage, the most promising method that has been considered is latent heat storage associated with molten salt mixtures as phase-change material (PCM). The binary salt mixture lithium chloride—lithium hydroxide (LiCl–LiOH) with a specific composition can store thermal energy. However, to the best of our knowledge, there is no information on their thermal stability in previous literature. The key objectives of this article were to investigate the thermophysical properties, thermal repeatability, and thermal decomposition behavior of the chosen binary salt mixture. FactSage software was used to determine the composition of the binary salt mixture. Thermophysical properties were investigated with a simultaneous thermal analyzer (STA). The thermal results show that the binary salt 32 mol% LiCl-68 mol% LiOH melts within the range of 269 °C to 292 °C and its heat of fusion is 379 J/g. Thermal repeatability was tested with a thermogravimetric analyzer (TGA) for 30 heating and cooling cycles, which resulted in little change to the melting temperature and heat of fusion. Thermal decomposition analysis indicated negligible weight loss until 500 °C and showed good thermal stability. Chemical and structural instability was verified by X-ray diffraction (XRD) by analysing the binary salt system before and after thermal treatment. A minor peak corresponding to lithium oxide was observed in the sample decomposed at 700 °C which resulted from the decomposition of LiOH at high temperature. The morphology and elemental distribution examinations of the binary salt mixture were carried out via scanning electron microscopy (SEM) coupled with energy dispersive spectroscopy (EDS). X-ray photoelectron spectroscopy was conducted for surface analysis, and their elemental composition verified the chemical stability of the binary salt mixture. Overall, the results confirmed that the binary salt mixture is a potential candidate to be used as thermal energy storage material in energy storage applications of up to 500 °C.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Surface Analysis and Materials Engineering Research Group, College of Science, Health, Engineering and Education, Murdoch University, Perth, WA 6150, Australia.
- College of Science, Health, Engineering and Education, Murdoch University, Perth, WA 6150, Australia.
- Centre for Energy, Water, and Waste, Harry Butler Institute, Murdoch University, Perth, WA 6150, Australia.
- Faculty of Engineering, Universiti Malaysia Sabah, Jalan UMS, Kota Kinabalu 88400, Malaysia.
ORCID-Profile: Manickam Minakshi
Zitieren
APA
Hassan, N., Minakshi, M., Ruprecht, J., Liew, W. Y. H., & Jiang, Z. T. (2023). A Binary Salt Mixture LiCl–LiOH for Thermal Energy Storage. Materials, 16(4), 1434. https://doi.org/10.3390/ma16041434
Vancouver
Hassan N, Minakshi M, Ruprecht J, Liew WYH, Jiang ZT. A Binary Salt Mixture LiCl–LiOH for Thermal Energy Storage. Materials. 2023;16(4):1434. doi:10.3390/ma16041434
BibTeX
@article{Hassan2023,
author = {Hassan, Naveed and Minakshi, Manickam and Ruprecht, John and Liew, Willey Yun Hsien and Jiang, Zhong-Tao},
title = {A Binary Salt Mixture LiCl–LiOH for Thermal Energy Storage},
journal = {Materials},
year = {2023},
volume = {16},
number = {4},
pages = {1434},
doi = {10.3390/ma16041434}
}
EUVIMED