EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel

Quanshun Luo iD, Matthew Kitchen

Materials · 28.01.2023 · 16 (3) · 1117

DOI: 10.3390/ma16031117 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 28.01.2023. Verfasst von Quanshun Luo und 1 weiteren Autor:innen. Beteiligte Einrichtung: Materials and Engineering Research Institute, Sheffield Hallam University, Sheffield S1 1WB, UK. Die Arbeit wurde bisher 28-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microhardness testing is a widely used method for measuring the hardness property of small-scale materials. However, pronounced indentation size effect (ISE) causes uncertainties when the method is used to estimate the real hardness. In this paper, three austenitic Hadfield steel samples of different plastic straining conditions were subjected to Vickers microhardness testing, using a range of loads from 10 to 1000 g. The obtained results reveal that the origin of ISE is derived from the fact, that the indentation load P and the resultant indent diagonal d do not obey Kick’s law (P = A · d2). Instead, the P and d parameters obey Meyer’s power law (P = A · dn) with n < 2. The plastically strained samples showed not only significant work hardening, but also different ISE significance, as compared to the non-deformed bulk steel. After extensive assessment of several theoretical models, including the Hays-Kendall model, Li-Bradt model, Bull model and Nix-Gao model, it was found that the real hardness can be determined by Vickers microhardness indentation and subsequent analysis using the Nix-Gao model. The newly developed method was subsequently utilised in two case studies to determine the real hardness properties of sliding worn surfaces and the subsurface hardness profile.

Schlagwörter

Stichwörter der Autor:innen

Hadfield steelMeyer’s power lawNix-Gao modelindentation size effect (ISE)real hardnessstraining hardening

Autor:innen und Institutionen

  • Materials and Engineering Research Institute, Sheffield Hallam University, Sheffield S1 1WB, UK.

ORCID-Profile: Quanshun Luo

Zitieren

APA

Luo, Q., & Kitchen, M. (2023). Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel. Materials, 16(3), 1117. https://doi.org/10.3390/ma16031117

Vancouver

Luo Q, Kitchen M. Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel. Materials. 2023;16(3):1117. doi:10.3390/ma16031117

BibTeX
@article{Luo2023,
  author = {Luo, Quanshun and Kitchen, Matthew},
  title = {Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {3},
  pages = {1117},
  doi = {10.3390/ma16031117}
}
Kostenlos starten →