EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Synthesis of Ti3SiC2 Phases and Consolidation of MAX/SiC Composites—Microstructure and Mechanical Properties

Jaroslaw Wozniak iD, Mateusz Petrus iD, Tomasz Cygan iD, Boguslawa Adamczyk-Cieślak iD, Dorota Moszczyńska, Andrzej Roman Olszyna iD

Materials · 17.01.2023 · 16 (3) · 889

DOI: 10.3390/ma16030889 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 17.01.2023. Verfasst von Jaroslaw Wozniak und 5 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Material Science and Engineering, Warsaw University of Technology, 02-507 Warsaw, Poland. Die Arbeit wurde bisher 19-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and the Higher Education Republic of Poland.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The article describes the Ti3SiC2 powder synthesis process. The influence of the molar ratio and two forms of carbon on the phase composition of the obtained powders was investigated. The synthesis was carried out using a spark plasma sintering (SPS) furnace. In addition, using the obtained powders, composites reinforced with SiC particles were produced. The obtained results showed no effect of the carbon form and a significant impact of annealing on the purity of the powders after synthesis. The composites were also consolidated using an SPS furnace at two temperatures of 1300 and 1400 °C. The tests showed low density and hardness for sinters from 1300 °C (maximum 3.97 g/cm3 and 447 HV5, respectively, for composite reinforced with 10% SiC). These parameters significantly increase for composites sintered at 1400 °C (maximum density 4.43 g/cm3 and hardness 1153 HV5, for Ti3AlC2—10% SiC). In addition, the crack propagation analysis showed mechanisms typical for granular materials and laminates.

Schlagwörter

Stichwörter der Autor:innen

MAX phasesSiCcompositesmechanical propertiessintering

Autor:innen und Institutionen

  • Faculty of Material Science and Engineering, Warsaw University of Technology, 02-507 Warsaw, Poland.

ORCID-Profile: Jaroslaw Wozniak, Mateusz Petrus, Tomasz Cygan, Boguslawa Adamczyk-Cieślak, Andrzej Roman Olszyna

Förderung

  • Ministry of Science and the Higher Education Republic of Poland

Zitieren

APA

Wozniak, J., Petrus, M., Cygan, T., Adamczyk-Cieślak, B., Moszczyńska, D., & Olszyna, A. R. (2023). Synthesis of Ti3SiC2 Phases and Consolidation of MAX/SiC Composites—Microstructure and Mechanical Properties. Materials, 16(3), 889. https://doi.org/10.3390/ma16030889

Vancouver

Wozniak J, Petrus M, Cygan T, Adamczyk-Cieślak B, Moszczyńska D, Olszyna AR. Synthesis of Ti3SiC2 Phases and Consolidation of MAX/SiC Composites—Microstructure and Mechanical Properties. Materials. 2023;16(3):889. doi:10.3390/ma16030889

BibTeX
@article{Wozniak2023,
  author = {Wozniak, Jaroslaw and Petrus, Mateusz and Cygan, Tomasz and Adamczyk-Cieślak, Boguslawa and Moszczyńska, Dorota and Olszyna, Andrzej Roman},
  title = {Synthesis of Ti3SiC2 Phases and Consolidation of MAX/SiC Composites—Microstructure and Mechanical Properties},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {3},
  pages = {889},
  doi = {10.3390/ma16030889}
}
Kostenlos starten →