EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks

Mauricio Gago, Arkadi Kreter, Bernhard Unterberg, Marius Wirtz

Journal of Nuclear Engineering · 21.02.2023 · 4 (1) · 204-212

DOI: 10.3390/jne4010016 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Nuclear Engineering, online erschienen am 21.02.2023. Verfasst von Mauricio Gago und 3 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: European Union via the Euratom Research and Training Programme.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Plasma-facing materials (PFMs) in the ITER divertor will be exposed to severe conditions, including exposure to transient heat loads from edge-localized modes (ELMs) and to plasma particles and neutrons. Tungsten is the material chosen as PFM for the ITER divertor. In previous tests, bubble formation in ITER-grade tungsten was detected when exposed to fusion relevant conditions. For this study, ITER-grade tungsten was exposed to simultaneous ELM-like transient heat loads and D/He (6%) plasma in the linear plasma device PSI-2. Bubble formation was then investigated via SEM micrographs and FIB cuts. It was found that for exposure to 100.000 laser pulses of 0.6 GWm−2 absorbed power density (Pabs), only small bubbles in the nanometer range were formed close to the surface. After increasing Pabs to 0.8 and 1.0 GWm−2, the size of the bubbles went up to about 1 µm in size and were deeper below the surface. Increasing the plasma fluence had an even larger effect, more than doubling bubble density and increasing bubble size to up to 2 µm in diameter. When using deuterium-only plasma, the samples showed no bubble formation and reduced cracking, showing such bubble formation is caused by exposure to helium plasma.

Förderung

  • European Union via the Euratom Research and Training Programme

Zitieren

APA

Gago, M., Kreter, A., Unterberg, B., & Wirtz, M. (2023). Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks. Journal of Nuclear Engineering, 4(1), 204-212. https://doi.org/10.3390/jne4010016

Vancouver

Gago M, Kreter A, Unterberg B, Wirtz M. Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks. Journal of Nuclear Engineering. 2023;4(1):204-212. doi:10.3390/jne4010016

BibTeX
@article{Gago2023,
  author = {Gago, Mauricio and Kreter, Arkadi and Unterberg, Bernhard and Wirtz, Marius},
  title = {Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks},
  journal = {Journal of Nuclear Engineering},
  year = {2023},
  volume = {4},
  number = {1},
  pages = {204--212},
  doi = {10.3390/jne4010016}
}
Kostenlos starten →