Effects of Current Conditions and Mooring-Line Arrangements on Mooring Forces of Immersed Tube Segments
Journal of Marine Science and Engineering · 12.08.2026 · 14 (16) · 1491
DOI: 10.3390/jmse14161491 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Marine Science and Engineering, online erschienen am 12.08.2026. Verfasst von Ting Ji und 6 weiteren Autor:innen. Die Arbeit nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Industry-University-Research Cooperation Project of CCCC Fourth Harbor Engineering Co., Ltd., Guangdong Provincial Key Laboratory of Intelligent Disaster Prevention and Emergency Technologies for Urban Lifeline Engineering.
Abstract (Originalsprache)
During the floating transportation and installation of immersed tube tunnels, the mechanical stability of the mooring system is a key factor governing construction safety. Current conditions and mooring-line arrangements are two major factors controlling the magnitude and distribution of mooring-line tensions. However, their coupled effects and the applicability of different calculation methods remain insufficiently understood. Based on a large-cross-section immersed tube tunnel project, this study employed a semi-empirical method specified in the Chinese Code for Loads on Port Engineering and a three-dimensional floating-body-mooring numerical model established in ANSYS AQWA. Multiple combinations of current velocity and direction were considered to compare the mooring-line responses under five typical arrangements corresponding to different construction stages. The effects of current conditions and mooring configurations on the magnitude, distribution, and transfer of mooring-line loads were systematically examined. The results show that current velocity is the dominant factor controlling the magnitude of mooring-line tensions, which generally increase with the square of the current velocity. Changes in current direction directly alter the principal load-bearing mooring-line group, and a current velocity of 1.5 m/s during the falling tide represents the most unfavorable current condition throughout the construction process. The mooring-line arrangement governs the spatial distribution and concentration of the line loads. During the floating transportation and mooring stages with multi-line constraints, the maximum mooring-line tensions calculated using China’s code-based method are 18.5–25.2% higher than those obtained from the numerical simulations, indicating relatively conservative predictions. In contrast, during stages with weakened constraints, such as line release and positioning in the foundation trench, the numerical model captures more pronounced local load concentration, yielding maximum tensions 19.4–28.8% higher than those predicted by the code-based method. Across all operating conditions, the maximum mooring-line tensions calculated by the code-based method and numerical model are 924 and 750 kN, respectively. This study clarifies the coupled effects of current conditions and mooring-line arrangements on mooring-load transfer and identifies the applicable scenarios of the two calculation methods. The findings provide a quantitative basis for calculation-method selection, mooring-force assessment, and construction-safety management during immersed tube tunnel installation.
Förderung
- National Natural Science Foundation of China
- Industry-University-Research Cooperation Project of CCCC Fourth Harbor Engineering Co., Ltd.
- Guangdong Provincial Key Laboratory of Intelligent Disaster Prevention and Emergency Technologies for Urban Lifeline Engineering
- Dongguan Key Laboratory of Green and Low-Carbon Construction and Intelligent Disaster Prevention in Marine Engineering Structures
Zitieren
APA
Ji, T., Yang, Y., Zhang, W., Yu, P., Chen, J., Yu, L., & Li, J. (2026). Effects of Current Conditions and Mooring-Line Arrangements on Mooring Forces of Immersed Tube Segments. Journal of Marine Science and Engineering, 14(16), 1491. https://doi.org/10.3390/jmse14161491
Vancouver
Ji T, Yang Y, Zhang W, Yu P, Chen J, Yu L, et al. Effects of Current Conditions and Mooring-Line Arrangements on Mooring Forces of Immersed Tube Segments. Journal of Marine Science and Engineering. 2026;14(16):1491. doi:10.3390/jmse14161491
BibTeX
@article{Ji2026,
author = {Ji, Ting and Yang, Yang and Zhang, Wensen and Yu, Peng and Chen, Jiuchao and Yu, Lie and Li, Junhao},
title = {Effects of Current Conditions and Mooring-Line Arrangements on Mooring Forces of Immersed Tube Segments},
journal = {Journal of Marine Science and Engineering},
year = {2026},
volume = {14},
number = {16},
pages = {1491},
doi = {10.3390/jmse14161491}
}
EUVIMED