EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Modelling of Synthetic Fibre Rope Mooring for Floating Offshore Wind Turbines

Stian H. Sørum, Nuno Fonseca, Michael Kent, Rui Pedro Faria

Journal of Marine Science and Engineering · 12.01.2023 · 11 (1) · 193

DOI: 10.3390/jmse11010193 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Marine Science and Engineering, online erschienen am 12.01.2023. Verfasst von Stian H. Sørum und 3 weiteren Autor:innen. Die Arbeit wurde bisher 24-mal zitiert (Crossref) und nennt 24 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: European Union’s Horizon 2020 research.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Fibre ropes offer beneficial properties for mooring of floating offshore wind turbines (FOWTs). However, the mooring line’s stiffness is both load-history and load-rate dependent. A quasi-static stiffness is observed for slow loading, with a higher stiffness related to rapid, cyclic loading (dynamic stiffness). Design standards provide different guidelines for how to combine these in the mooring analysis. This paper describes procedures for adapting laboratory test stiffness results to the Syrope and a bi-linear model and investigates the consequence of using the models for load calculations. The Syrope model accounts for the quasi-static and permanent rope elongation, while performing the analyses with the dynamic stiffness. The bi-linear model applies both the quasi-static and dynamic stiffness in the dynamic analyses. Based on fibre rope tests performed by Bridon-Bekaert, a Syrope model and two bi-linear models are adapted to the same fibre rope. Fatigue damage and ultimate loads on the mooring lines of Saitec’s SATH FOWT are calculated. The bi-linear model artificially reduces the tension ranges, particularly if there is a large difference between the quasi-static and dynamic stiffness of the fibre rope. This leads to a longer predicted fatigue lifetime. Differences in the extreme loads are caused by the permanent elongation of the Syrope model. This may be countered if the elongation is known and included in the bi-linear model. Finally, the bi-linear model introduces an amplitude-dependency in the horizontal natural periods.

Förderung

  • European Union’s Horizon 2020 research

Zitieren

APA

Sørum, S. H., Fonseca, N., Kent, M., & Faria, R. P. (2023). Modelling of Synthetic Fibre Rope Mooring for Floating Offshore Wind Turbines. Journal of Marine Science and Engineering, 11(1), 193. https://doi.org/10.3390/jmse11010193

Vancouver

Sørum SH, Fonseca N, Kent M, Faria RP. Modelling of Synthetic Fibre Rope Mooring for Floating Offshore Wind Turbines. Journal of Marine Science and Engineering. 2023;11(1):193. doi:10.3390/jmse11010193

BibTeX
@article{Srum2023,
  author = {Sørum, Stian H. and Fonseca, Nuno and Kent, Michael and Faria, Rui Pedro},
  title = {Modelling of Synthetic Fibre Rope Mooring for Floating Offshore Wind Turbines},
  journal = {Journal of Marine Science and Engineering},
  year = {2023},
  volume = {11},
  number = {1},
  pages = {193},
  doi = {10.3390/jmse11010193}
}
Kostenlos starten →