Selection of Welding Conditions for Achieving Both a High Efficiency and Low Heat Input for Hot-Wire Gas Metal Arc Welding
Journal of Manufacturing and Materials Processing · 18.04.2024 · 8 (2) · 82
DOI: 10.3390/jmmp8020082 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 18.04.2024. Verfasst von Keita Marumoto und 4 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 25 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study presents a new gas metal arc welding (GMAW) technique that achieves both high efficiency and low heat input using a hybridization of the hot-wire method. The optimal combination of welding speed and welding current conditions was investigated using a fixed hot-wire feeding speed of 10 m/min on a butt joint with a V-shaped groove using 19 mm thick steel plates. Molten pool stability and defect formation were observed using high-speed imaging and cross-sectional observations. The power consumption and heat input were predicted prior to welding and measured in the experiments. The results indicate that a combination of a welding current of 350–500 A and welding speed of 0.3–0.7 m/min is optimal to avoid defect formation and molten metal precedence using three or four passes. The higher efficiency and lower heat input achieved by hot-wire GMAW results in a weld metal of adequate hardness, narrower heat-affected zone, smaller grain size at the fusion boundary, and lower power consumption than those obtained using tandem GMAW and high-current GMAW. Based on the experimental results, a single bevel groove, which is widely used in construction machinery welding joints, was welded using hot-wire GMAW, and we confirmed that the welding part could be welded in six passes, whereas eight passes were required with GMAW only.
Zitieren
APA
Marumoto, K., Fujinaga, A., Takahashi, T., Yamamoto, H., & Yamamoto, M. (2024). Selection of Welding Conditions for Achieving Both a High Efficiency and Low Heat Input for Hot-Wire Gas Metal Arc Welding. Journal of Manufacturing and Materials Processing, 8(2), 82. https://doi.org/10.3390/jmmp8020082
Vancouver
Marumoto K, Fujinaga A, Takahashi T, Yamamoto H, Yamamoto M. Selection of Welding Conditions for Achieving Both a High Efficiency and Low Heat Input for Hot-Wire Gas Metal Arc Welding. Journal of Manufacturing and Materials Processing. 2024;8(2):82. doi:10.3390/jmmp8020082
BibTeX
@article{Marumoto2024,
author = {Marumoto, Keita and Fujinaga, Akira and Takahashi, Takeshi and Yamamoto, Hikaru and Yamamoto, Motomichi},
title = {Selection of Welding Conditions for Achieving Both a High Efficiency and Low Heat Input for Hot-Wire Gas Metal Arc Welding},
journal = {Journal of Manufacturing and Materials Processing},
year = {2024},
volume = {8},
number = {2},
pages = {82},
doi = {10.3390/jmmp8020082}
}
EUVIMED