Method for Defining Parameters of Electromechanical System Model as Part of Digital Twin of Rolling Mill
Journal of Manufacturing and Materials Processing · 12.10.2023 · 7 (5) · 183
DOI: 10.3390/jmmp7050183 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 12.10.2023. Verfasst von Vadim R. Gasiyarov und 6 weiteren Autor:innen. Die Arbeit wurde bisher 24-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Moscow Polytechnic University.
Abstract (Originalsprache)
Creating digital twins of industrial equipment requires the development of adequate virtual models, and the calculation of their parameters is a complex scientific and practical problem. To configure and digitally commission automated drives, two-mass electromechanical system models are used. A promising area in which to implement such models is the development of digital shadows, namely drive position observers. Connecting virtual models for online data exchange predetermines the tightening of requirements for their parameter calculation accuracy. Therefore, developing accessible techniques for calculating electromechanical system coordinates is an urgent problem. These parameters are most accurately defined by experiments. The contribution of this paper is the proposition of a method for defining the two-mass system model parameters using the oscillograms obtained in the operating and emergency modes. The method is developed for the horizontal stand drives of a plate mill 5000 and is supported by numerical examples. The technique is universal and comprises calculating the rotating mass inertia torques, elastic stiffness and oscillation damping coefficients, and the time constants of the motor air gap torque control loop. The obtained results have been applied to the development of the elastic torque observer of the rolling stand’s electromechanical system. A satisfactory coordinate recovery accuracy has been approved for both open and closed angular gaps in mechanical joints. Recommendations are given for the use of the method in developing process parameter control algorithms based on automated drive position observers. This contributes to the development of the theory and practice of building digital control systems and the implementation of the Industry 4.0 concept in industrial companies.
Förderung
- Moscow Polytechnic University
Zitieren
APA
Gasiyarov, V. R., Radionov, A. A., Loginov, B. M., Zinchenko, M. A., Gasiyarova, O. A., Karandaev, A. S., & Khramshin, V. R. (2023). Method for Defining Parameters of Electromechanical System Model as Part of Digital Twin of Rolling Mill. Journal of Manufacturing and Materials Processing, 7(5), 183. https://doi.org/10.3390/jmmp7050183
Vancouver
Gasiyarov VR, Radionov AA, Loginov BM, Zinchenko MA, Gasiyarova OA, Karandaev AS, et al. Method for Defining Parameters of Electromechanical System Model as Part of Digital Twin of Rolling Mill. Journal of Manufacturing and Materials Processing. 2023;7(5):183. doi:10.3390/jmmp7050183
BibTeX
@article{Gasiyarov2023,
author = {Gasiyarov, Vadim R. and Radionov, Andrey A. and Loginov, Boris M. and Zinchenko, Mark A. and Gasiyarova, Olga A. and Karandaev, Alexander S. and Khramshin, Vadim R.},
title = {Method for Defining Parameters of Electromechanical System Model as Part of Digital Twin of Rolling Mill},
journal = {Journal of Manufacturing and Materials Processing},
year = {2023},
volume = {7},
number = {5},
pages = {183},
doi = {10.3390/jmmp7050183}
}
EUVIMED