EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Determining Univariate Equivalency of Additively Manufactured Parts

Colin M. Lynch, Rene Villalobos, Brenda Leticia Valadez Mesta, Cesar Gomez Guillen, Jorge Mireles, Ryan B. Wicker

Journal of Manufacturing and Materials Processing · 17.04.2026 · 10 (4) · 134

DOI: 10.3390/jmmp10040134 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 17.04.2026. Verfasst von Colin M. Lynch und 5 weiteren Autor:innen. Die Arbeit nennt 72 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Air Force Research Laboratory, discretionary UTEP Keck Center funds, Mr. and Mrs. MacIntosh Murchison Chair I in Engineering Endowment at UTEP.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing (AM) requires process-comparison tools that remain practical when sample generation and testing are costly. We propose a univariate, nonparametric workflow for comparing a candidate AM process to a stable reference process by testing distributional equivalency for a single response variable. The method discretizes the reference distribution into empirical percentile-defined bins and combines this representation with a sequential sampling protocol designed to reduce unnecessary sampling when evidence for equivalency or non-equivalency becomes sufficient. Simulation studies were used to evaluate operating characteristics across experimental settings, and a validation case study based on geometric measurements of laser based powder bed fusion plate scans correctly classified a candidate process expected to be equivalent to the reference while identifying a non-equivalent process at the first sampling step. The workflow is most appropriate for low-sample, high-cost, or throughput-constrained settings, and is best viewed as a tool for process comparability, change control, calibration, and requalification support rather than as a standalone replacement for qualification standards. The full workflow is implemented in the open-source AMEquivalency package to support reproducible analysis.

Förderung

  • Air Force Research Laboratory
  • discretionary UTEP Keck Center funds
  • Mr. and Mrs. MacIntosh Murchison Chair I in Engineering Endowment at UTEP

Zitieren

APA

Lynch, C. M., Villalobos, R., Mesta, B. L. V., Guillen, C. G., Mireles, J., & Wicker, R. B. (2026). Determining Univariate Equivalency of Additively Manufactured Parts. Journal of Manufacturing and Materials Processing, 10(4), 134. https://doi.org/10.3390/jmmp10040134

Vancouver

Lynch CM, Villalobos R, Mesta BLV, Guillen CG, Mireles J, Wicker RB. Determining Univariate Equivalency of Additively Manufactured Parts. Journal of Manufacturing and Materials Processing. 2026;10(4):134. doi:10.3390/jmmp10040134

BibTeX
@article{Lynch2026,
  author = {Lynch, Colin M. and Villalobos, Rene and Mesta, Brenda Leticia Valadez and Guillen, Cesar Gomez and Mireles, Jorge and Wicker, Ryan B.},
  title = {Determining Univariate Equivalency of Additively Manufactured Parts},
  journal = {Journal of Manufacturing and Materials Processing},
  year = {2026},
  volume = {10},
  number = {4},
  pages = {134},
  doi = {10.3390/jmmp10040134}
}
Kostenlos starten →