EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development of Simplified Mechanical Model for Welding Deformation in Multi-Pass Welding

Wenda Wang, Shintaro Maeda, Kazuki Ikushima, Masakazu Shibahara

Journal of Manufacturing and Materials Processing · 12.03.2026 · 10 (3) · 96

DOI: 10.3390/jmmp10030096 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 12.03.2026. Verfasst von Wenda Wang und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Japan Science and Technology Agency (JST) SPRING.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper proposes a simplified mechanical model to estimate transverse shrinkage and angular distortion in multi-pass butt welding. The simplified mechanical model is first derived for an I-groove joint by representing the heated weld region with one-dimensional bar elements and by enforcing force equilibrium to obtain closed-form expressions for pass-by-pass deformation increments and cumulative deformation. For non-I-groove joints, the same simplified mechanical model is applied by updating the layer partition and geometric parameters for each pass based on the pass-wise high-temperature region; the inherent shrinkage of each pass is evaluated from the heat input and an equivalent heated-layer thickness. The simplified mechanical model is validated for V-groove multi-pass joints by comparison with thermo-elastic-plastic finite element (FE) analyses and available experimental data, and for X-groove multi-pass joints by comparison with thermo-elastic-plastic FE analyses. In addition, a parametric study on the V-groove angle (40°–70°) for SUS316L demonstrates that the model captures the increasing trend of final transverse shrinkage with groove angle without a pronounced degradation in prediction accuracy. The results show that the simplified mechanical model reproduces both deformation histories and final values with good accuracy while using only a small set of input parameters and negligible computational cost, making it useful for early-stage welding procedure planning and quick parameter studies.

Förderung

  • Japan Science and Technology Agency (JST) SPRING

Zitieren

APA

Wang, W., Maeda, S., Ikushima, K., & Shibahara, M. (2026). Development of Simplified Mechanical Model for Welding Deformation in Multi-Pass Welding. Journal of Manufacturing and Materials Processing, 10(3), 96. https://doi.org/10.3390/jmmp10030096

Vancouver

Wang W, Maeda S, Ikushima K, Shibahara M. Development of Simplified Mechanical Model for Welding Deformation in Multi-Pass Welding. Journal of Manufacturing and Materials Processing. 2026;10(3):96. doi:10.3390/jmmp10030096

BibTeX
@article{Wang2026,
  author = {Wang, Wenda and Maeda, Shintaro and Ikushima, Kazuki and Shibahara, Masakazu},
  title = {Development of Simplified Mechanical Model for Welding Deformation in Multi-Pass Welding},
  journal = {Journal of Manufacturing and Materials Processing},
  year = {2026},
  volume = {10},
  number = {3},
  pages = {96},
  doi = {10.3390/jmmp10030096}
}
Kostenlos starten →