MATLAB-Assisted EKV-gm/ID Design Procedure for Two-Stage Miller-Compensated CMOS OTAs Starting from Closed-Loop Specifications
Journal of Low Power Electronics and Applications · 05.11.2026 · 16 (4) · 53
DOI: 10.3390/jlpea16040053 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Low Power Electronics and Applications, online erschienen am 05.11.2026. Verfasst von Marcello De Matteis. Die Arbeit nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This paper presents a MATLAB-assisted EKV–gm/ID methodology for the systematic synthesis of fully differential two-stage Miller-compensated CMOS OTAs. A sensitivity-based analysis maps the required closed-loop gain, bandwidth, and noise into OTA-level targets. An EKV-inspired analytical model, independently calibrated for nMOS and pMOS devices, provides continuous ID/W, gm/W and gm/ID characteristics with errors below 5% in the design region. Noise-driven sizing explicitly accounts for the different carrier mobilities of the pMOS differential pair and nMOS active load. Transistor parasitic capacitances are estimated from bias-dependent Cgg–VGS characteristics, thereby capturing the reduced gate capacitance of devices operating in moderate or weak inversion. The framework automatically generates transistor dimensions, bias conditions, and Miller-compensation components. These parameters are transferred directly from MATLAB to CADENCE without simulator-assisted resizing or optimization, except for width quantization into 5 μm/300 nm fingers. In 0.18 μm CMOS implementation, MATLAB and nominal CADENCE simulations predict, respectively, 61.80 and 59.27 dB DC gain, 430.78 and 431.52 MHz unity-gain bandwidth, 69.24° and 68.81° phase margin, 5.0 and 5.3 nV/√Hz input-referred noise at 100 MHz, and 1.426 and 1.314 mW core power. Robustness is assessed over 45 process-voltage-temperature corners, where the nominal solution remains close to the center of the evaluated performance distributions. The results confirm accurate nominal prediction and stable transistor-level behavior across PVT conditions and demonstrate that the proposed methodology accurately designs the OTA operating point, small-signal dynamics, and noise behavior, enabling transistor-level sizing directly from system-level specifications without iterative simulator-assisted optimization.
Zitieren
APA
Matteis, M. D. (2026). MATLAB-Assisted EKV-gm/ID Design Procedure for Two-Stage Miller-Compensated CMOS OTAs Starting from Closed-Loop Specifications. Journal of Low Power Electronics and Applications, 16(4), 53. https://doi.org/10.3390/jlpea16040053
Vancouver
Matteis MD. MATLAB-Assisted EKV-gm/ID Design Procedure for Two-Stage Miller-Compensated CMOS OTAs Starting from Closed-Loop Specifications. Journal of Low Power Electronics and Applications. 2026;16(4):53. doi:10.3390/jlpea16040053
BibTeX
@article{Matteis2026,
author = {Matteis, Marcello De},
title = {MATLAB-Assisted EKV-gm/ID Design Procedure for Two-Stage Miller-Compensated CMOS OTAs Starting from Closed-Loop Specifications},
journal = {Journal of Low Power Electronics and Applications},
year = {2026},
volume = {16},
number = {4},
pages = {53},
doi = {10.3390/jlpea16040053}
}
EUVIMED