EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of ZnO Nanoparticles on the Color and Surface Roughness of Composite and Glass-Ionomer Materials

Sanja Ilić iD, Neda Ninkovic, Branislav Sredanovic iD, Goran Vučić iD, Ljiljana Božić iD, Ljubica Škrbić iD, Jovana Kuzmanovic Pficer iD, Dragica Manojlovic iD

Journal of Functional Biomaterials · 15.07.2026 · 17 (7) · 343

DOI: 10.3390/jfb17070343 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Functional Biomaterials, online erschienen am 15.07.2026. Verfasst von Sanja Ilić und 7 weiteren Autor:innen. Beteiligte Einrichtung: Dental Clinic, Faculty of Medicine, University of Banja Luka, Bulevar vojvode Petra Bojovića 1a, 78000 Banja Luka, Bosnia and Herzegovina. Die Arbeit nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Ministry of Science, Technological Development and Innovations, Ministry of Science, Technological Development and Innovations, Republic of Serbia.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

The effect of incorporating various concentrations of 210 nm ZnO nanoparticles (ZnO-NPs) into resin-based composites (RBCs) and glass-ionomer cement (GIC) on their color and surface roughness after immersion in red wine is evaluated. Materials and Methods: 12 experimental groups (n = 12) were tested, including three commercial restorative materials: a microhybrid RBC (Gradia Direct®), a nanohybrid RBC (Evetric®) and a GIC (Fuji IX®). These were modified with ZnO-NPs at weight concentrations of 1%, 2%, and 3%. Color coordinates (L*,a*,b*) were measured using a spectrophotometer (CIEDE2000 formula) before and after 24 h immersion in red wine (37 °C). Surface roughness (Ra) was analyzed using contact profilometry.

Results

The addition of ZnO-NPs increased the lightness (L*) and decreased the a* values in all materials. In resin-based composites, even a 1% concentration of ZnO-NPs caused a color change above the clinical acceptability threshold (ΔE00 > 1.8; observed values ranged from 3.2 to 8.0). After immersion in wine, all materials exhibited further discoloration (ΔE00 up to 12.5 for composites). Surface roughness values increased from 0.42 μm (control composite) to 1.95 μm (3% ZnO-NP-modified GIC).

Conclusions

Addition of ZnO-NPs influences the aesthetics and topography of restorative materials. Their concentration must be balanced to maintain visual and surface integrity.

Schlagwörter

Stichwörter der Autor:innen

color stabilitycomposite resinsglass ionomer cementssurface roughnesszinc oxide nanoparticles

Autor:innen und Institutionen

  • Dental Clinic, Faculty of Medicine, University of Banja Luka, Bulevar vojvode Petra Bojovića 1a, 78000 Banja Luka, Bosnia and Herzegovina.
  • Department of Restorative Odontology and Endodontics, School of Dental Medicine, University of Belgrade, Rankeova 4, 11000 Belgrade, Serbia.
  • Department for Production and Computer Aided Technologies, Faculty of Mechanical Engineering, University of Banja Luka, Bulevar vojvode Stepe Stepanovića 71, 78000 Banja Luka, Bosnia and Herzegovina.
  • Faculty of Technology, University of Banja Luka, Bulevar vojvode Stepe Stepanovića 73, 78000 Banja Luka, Bosnia and Herzegovina.
  • Department of Microbiology and Immunology, Faculty of Medicine, University of Banja Luka, Save Mrkalja 14, 78000 Banja Luka, Bosnia and Herzegovina.
  • Department for Medical Statistics and Informatics, School of Dental Medicine, University of Belgrade, Dr. Subotica 1, 11000 Belgrade, Serbia.

ORCID-Profile: Sanja Ilić, Branislav Sredanovic, Goran Vučić, Ljiljana Božić, Ljubica Škrbić, Jovana Kuzmanovic Pficer, Dragica Manojlovic

Förderung

  • the Ministry of Science, Technological Development and Innovations
  • Ministry of Science, Technological Development and Innovations, Republic of Serbia

Zitieren

APA

Ilić, S., Ninkovic, N., Sredanovic, B., Vučić, G., Božić, L., Škrbić, L., Kuzmanovic Pficer, J., & Manojlovic, D. (2026). Influence of ZnO Nanoparticles on the Color and Surface Roughness of Composite and Glass-Ionomer Materials. Journal of Functional Biomaterials, 17(7), 343. https://doi.org/10.3390/jfb17070343

Vancouver

Ilić S, Ninkovic N, Sredanovic B, Vučić G, Božić L, Škrbić L, et al. Influence of ZnO Nanoparticles on the Color and Surface Roughness of Composite and Glass-Ionomer Materials. Journal of Functional Biomaterials. 2026;17(7):343. doi:10.3390/jfb17070343

BibTeX
@article{Ili2026,
  author = {Ilić, Sanja and Ninkovic, Neda and Sredanovic, Branislav and Vučić, Goran and Božić, Ljiljana and Škrbić, Ljubica and Kuzmanovic Pficer, Jovana and Manojlovic, Dragica},
  title = {Influence of ZnO Nanoparticles on the Color and Surface Roughness of Composite and Glass-Ionomer Materials},
  journal = {Journal of Functional Biomaterials},
  year = {2026},
  volume = {17},
  number = {7},
  pages = {343},
  doi = {10.3390/jfb17070343}
}
Kostenlos starten →