Molar Distalization by Clear Aligners with Sequential Distalization Protocol: A Systematic Review and Meta-Analysis
Journal of Functional Biomaterials · 21.05.2024 · 15 (6) · 137
DOI: 10.3390/jfb15060137 ↗Kurz gefasst
Übersichtsarbeit in der Zeitschrift Journal of Functional Biomaterials, online erschienen am 21.05.2024. Verfasst von Christie Shen und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Orthodontics, School of Dental Medicine, University of Pennsylvania, Philadelphia, PA 19104, USA. Die Arbeit wurde bisher 27-mal zitiert (Crossref) und nennt 70 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the American Association for Dental, Oral, and Craniofacial Research, NIH HHS, American Association of Orthodontists Foundation.
Abstract (Originalsprache)
Introduction
With the popularity of clear aligners, the sequential distalization protocol has been more commonly used for molar distalization. However, the amount of molar distalization that can be achieved, as well as the accompanying side effects on the sagittal dimension, are unclear.
Methods
Registered with PROSPERO (CRD42023447211), relevant original studies were screened from seven databases (MEDLINE [PubMed], EBSCOhost, Web of Science, Elsevier [SCOPUS], Cochrane, LILACS [Latin American and Caribbean Health Sciences Literature], and Google Scholar) supplemented by a manual search of the references of the full-reading manuscripts by two investigators independently. A risk of bias assessment was conducted, relevant data were extracted, and meta-analysis was performed using RStudio.
Results
After the screening, 13 articles (11 involving maxillary distalization, two involving mandibular distalization) met the inclusion criteria. All studies had a high or medium risk of bias. The meta-analysis revealed that the maxillary first molar (U6) mesiobuccal cusp was distalized 2.07 mm [1.38 mm, 2.77 mm] based on the post-distalization dental model superimposition, and the U6 crown was distalized 2.00 mm [0.77 mm, 3.24 mm] based on the post-treatment lateral cephalometric evaluation. However, the U6 mesiobuccal root showed less distalization of 1.13 mm [−1.34 mm, 3.60 mm], indicating crown distal tipping, which was validated by meta-analysis (U6-PP angle: 2.19° [1.06°, 3.33°]). In addition, intra-arch anchorage loss was observed at the post-distalization time point (U1 protrusion: 0.39 mm [0.27 mm, 0.51 mm]), which was corrected at the post-treatment time point (incisal edge-PTV distance: −1.50 mm [−2.61 mm, −0.39 mm]).
Conclusion
About 2 mm maxillary molar distalization can be achieved with the sequential distalization protocol, accompanied by slight molar crown distal tipping. Additional studies on this topic are needed due to the high risk of bias in currently available studies.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Orthodontics, School of Dental Medicine, University of Pennsylvania, Philadelphia, PA 19104, USA.
- School of Dental Medicine, University of Pennsylvania, Philadelphia, PA 19104, USA.
ORCID-Profile: Chenshuang Li
Förderung
- the American Association for Dental, Oral, and Craniofacial Research
- NIH HHS
- American Association of Orthodontists Foundation
- American Academy of Periodontology Foundation
- the Department of Orthodontics, University of Pennsylvania School of Dental Medicine
- University of Pennsylvania School of Dental Medicine
- NIDCR NIH HHS
- International Orthodontic Foundation
Zitieren
APA
Shen, C., Park, T. H., Chung, C. H., & Li, C. (2024). Molar Distalization by Clear Aligners with Sequential Distalization Protocol: A Systematic Review and Meta-Analysis. Journal of Functional Biomaterials, 15(6), 137. https://doi.org/10.3390/jfb15060137
Vancouver
Shen C, Park TH, Chung CH, Li C. Molar Distalization by Clear Aligners with Sequential Distalization Protocol: A Systematic Review and Meta-Analysis. Journal of Functional Biomaterials. 2024;15(6):137. doi:10.3390/jfb15060137
BibTeX
@article{Shen2024,
author = {Shen, Christie and Park, Tiffany H and Chung, Chun-Hsi and Li, Chenshuang},
title = {Molar Distalization by Clear Aligners with Sequential Distalization Protocol: A Systematic Review and Meta-Analysis},
journal = {Journal of Functional Biomaterials},
year = {2024},
volume = {15},
number = {6},
pages = {137},
doi = {10.3390/jfb15060137}
}
EUVIMED