Magnetic Separation of Oil Spills from Water Using Cobalt Ferrite Nanoparticles with Fluorocarbon Functionalization
International Journal of Molecular Sciences · 2025
DOI: 10.3390/ijms26146562 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Molecular Sciences, 2025. Verfasst von Aljoša Košak und 3 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Mechanical Engineering, Center for Sensor Technology, University of Maribor, Smetanova 17, 2000 Maribor, Slovenia. Hauptthemen laut MEDLINE: Cobalt, Ferric Compounds, Fluorocarbons, Petroleum Pollution. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 125 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Slovenian Research Agency, EU project OpenLOOP, Ministry of Education, Science and Sport of the Republic of Slovenia.
Abstract (Originalsprache)
In the present study, we synthesized fluorocarbon-coated cobalt ferrite (CoFe2O4) magnetic nanoparticles using alkoxysilanes such as trimethoxy(3,3,3-trifluoropropyl)silane (TFPTMS), trimethoxy(1H,1H,2H,2H-nonafluorohexyl)silane (NFHTMS), and triethoxy(1H,1H,2H,2H-perfluorodecyl)silane (PFDTES). The synthesized nanoparticles were characterized by various techniques, including X-ray diffractometry (XRD), transmission electron microscopy (TEM/HRTEM/EDXS), Fourier transform infrared spectroscopy (FTIR), specific surface area measurements (BET), and magnetometry (VSM). To understand their surface characteristics, contact angle (CA) measurements were carried out, providing valuable insights into their hydrophobic properties. Among the samples of CoFe2O4 coated with fluoroalkoxysilanes, those with PFDTES surface coating had the highest water contact angle of 159.2°, indicating their superhydrophobic character. The potential of the prepared fluoroalkoxysilane-coated CoFe2O4 nanoparticles for the removal of waste low-SAPS synthetic engine oil from a model aqueous solution was evaluated based on three key parameters: adsorption efficiency (%), adsorption capacity (mg/g), and desorption efficiency (%). All synthesized CoFe2O4 samples coated with fluoroalkoxysilane showed high oil adsorption efficiency, ranging from 87% to 98%. The average oil adsorption capacity for the samples was as follows: F3-SiO2@CoFe2O4 (3.1 g of oil/g of adsorbent) > F9-SiO2@CoFe2O4 (2.7 g of oil/g of adsorbent) > F17-SiO2@CoFe2O4 (1.5 g of oil/g of adsorbent) as a result of increasing oleophobicity with increasing fluorocarbon chain length. The desorption results, which showed 77–97% oil recovery, highlighted the possibility of reusing the adsorbents in multiple adsorption/desorption cycles.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Faculty of Mechanical Engineering, Center for Sensor Technology, University of Maribor, Smetanova 17, 2000 Maribor, Slovenia.
- Institute for Environmental Protection and Sensors (IOS) Ltd., Beloruska 7, 2000 Maribor, Slovenia.
ORCID-Profile: Ajra Hadela
Förderung
- Slovenian Research Agency
- EU project OpenLOOP
- Ministry of Education, Science and Sport of the Republic of Slovenia
Zitieren
APA
Košak, A., Hadela, A., Poberžnik, M., & Lobnik, A. (2025). Magnetic Separation of Oil Spills from Water Using Cobalt Ferrite Nanoparticles with Fluorocarbon Functionalization. International Journal of Molecular Sciences. https://doi.org/10.3390/ijms26146562
Vancouver
Košak A, Hadela A, Poberžnik M, Lobnik A. Magnetic Separation of Oil Spills from Water Using Cobalt Ferrite Nanoparticles with Fluorocarbon Functionalization. International Journal of Molecular Sciences. 2025. doi:10.3390/ijms26146562
BibTeX
@article{Koak2025,
author = {Košak, Aljoša and Hadela, Ajra and Poberžnik, Mojca and Lobnik, Aleksandra},
title = {Magnetic Separation of Oil Spills from Water Using Cobalt Ferrite Nanoparticles with Fluorocarbon Functionalization},
journal = {International Journal of Molecular Sciences},
year = {2025},
doi = {10.3390/ijms26146562}
}
EUVIMED