Electrocatalytic Performance of Ethanol Oxidation on Ni and Ni/Pd Surface-Decorated Porous Structures Obtained by Molten Salts Deposition/Dissolution of Al-Ni Alloys
International Journal of Molecular Sciences · 14.02.2023 · 24 (4) · 3836
DOI: 10.3390/ijms24043836 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Molecular Sciences, online erschienen am 14.02.2023. Verfasst von Dawid Kutyła und 4 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Non-Ferrous Metals, AGH University of Science and Technology in Kraków, Mickiewicza 30 Ave., 30-059 Krakow, Poland. Hauptthemen laut MEDLINE: Salts, Nickel. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: This research received funding by program "Excellence initiative - research university" for the University of Science and Technology in Kraków., “Excellence initiative—research university” for the University of Science and Technology in Kraków.
Abstract (Originalsprache)
Ni coatings with high catalytic efficiency were synthesised in this work, obtained by increasing the active surface and modifying Pd as a noble metal. Porous Ni foam electrodes were obtained by electrodeposition of Al on a nickel substrate. Deposition of Al was carried out with potential −1.9 V for a time of 60 min in NaCl–KCl-3.5 mol%AlF3 molten salt mixture at 900 °C, which is connected with the formation of the Al-Ni phase in the solid state. Dissolution of Al and Al-Ni phases was performed by application of the potential −0.5 V, which provided the porous layer formation. The obtained porous material was compared to flat Ni plates in terms of electrocatalytic properties for ethanol oxidation in alkaline solutions. Cyclic voltammetry measurements in the non-Faradaic region revealed the improvement in morphology development for Ni foams, with an active surface area 5.5-times more developed than flat Ni electrodes. The catalytic activity was improved by the galvanic displacement process of Pd(II) ions from dilute chloride solutions (1 mM) at different times. In cyclic voltammetry scans, the highest catalytic activity was registered for porous Ni/Pd decorated at 60 min, where the maximum oxidation peak for 1 M ethanol achieved +393 mA cm−2 compared to the porous unmodified Ni electrode at +152 mA cm−2 and flat Ni at +55 mA cm−2. Chronoamperometric measurements in ethanol oxidation showed that porous electrodes were characterised by higher catalytic activity than flat electrodes. In addition, applying a thin layer of precious metal on the surface of nickel increased the recorded anode current density associated with the electrochemical oxidation process. The highest activity was recorded for porous coatings after modification in a solution containing palladium ions, obtaining a current density value of about 55 mA cm−2, and for a flat unmodified electrode, only 5 mA cm−2 after 1800 s.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Faculty of Non-Ferrous Metals, AGH University of Science and Technology in Kraków, Mickiewicza 30 Ave., 30-059 Krakow, Poland.
- Department of Materials Science, Graduate School of Engineering Science, Akita University, Akita 010-8502, Japan.
ORCID-Profile: Dawid Kutyła, Michihisa Fukumoto, Marek Wojnicki, Karolina Kołczyk-Siedlecka
Förderung
- This research received funding by program "Excellence initiative - research university" for the University of Science and Technology in Kraków.
- “Excellence initiative—research university” for the University of Science and Technology in Kraków
Zitieren
APA
Kutyła, D., Nakajima, K., Fukumoto, M., Wojnicki, M., & Kołczyk-Siedlecka, K. (2023). Electrocatalytic Performance of Ethanol Oxidation on Ni and Ni/Pd Surface-Decorated Porous Structures Obtained by Molten Salts Deposition/Dissolution of Al-Ni Alloys. International Journal of Molecular Sciences, 24(4), 3836. https://doi.org/10.3390/ijms24043836
Vancouver
Kutyła D, Nakajima K, Fukumoto M, Wojnicki M, Kołczyk-Siedlecka K. Electrocatalytic Performance of Ethanol Oxidation on Ni and Ni/Pd Surface-Decorated Porous Structures Obtained by Molten Salts Deposition/Dissolution of Al-Ni Alloys. International Journal of Molecular Sciences. 2023;24(4):3836. doi:10.3390/ijms24043836
BibTeX
@article{Kutya2023,
author = {Kutyła, Dawid and Nakajima, Kano and Fukumoto, Michihisa and Wojnicki, Marek and Kołczyk-Siedlecka, Karolina},
title = {Electrocatalytic Performance of Ethanol Oxidation on Ni and Ni/Pd Surface-Decorated Porous Structures Obtained by Molten Salts Deposition/Dissolution of Al-Ni Alloys},
journal = {International Journal of Molecular Sciences},
year = {2023},
volume = {24},
number = {4},
pages = {3836},
doi = {10.3390/ijms24043836}
}
EUVIMED