Modelling of Truck Tire–Rim Slip on Sandy Loam Using Advanced Computational Techniques
Geotechnics · 25.02.2024 · 4 (1) · 229-241
DOI: 10.3390/geotechnics4010012 ↗Kurz gefasst
Fachartikel in der Zeitschrift Geotechnics, online erschienen am 25.02.2024. Verfasst von William Collings und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Vehicles often experience low tire pressures and high torques in off-road operations, making tire–rim slip likely. Tire–rim slip is undesirable relative rotation between the tire and rim, which, in this study, is measured by the relative tire–rim slip rate. There is little research on the effect of different terrains on tire–rim slip despite its significance for off-road driving; therefore, this topic was explored through Finite Element Analysis (FEA) simulations. An upland sandy loam soil was modelled and calibrated using Smoothed-Particle Hydrodynamics (SPH), and then a Regional Haul Drive (RHD) truck tire was simulated driving over this terrain, with a drawbar load added to increase drive torque. To examine their effects, five parameters were changed: tire–rim friction coefficient, longitudinal wheel speed, drawbar load, vertical load, and inflation pressure. The simulations showed that increasing the tire–rim friction coefficient and the inflation pressure decreased the tire–rim slip while increasing the vertical and drawbar loads increased the tire–rim slip. Varying the longitudinal wheel speed had no significant effect. Tire–rim slip was more likely to occur on the soil because it happened at lower drawbar loads on the soil than on the hard surface. These research results increased knowledge of tire–rim slip mechanics and provided a foundation for exploring tire–rim slip on other terrains, such as clays or sands.
Zitieren
APA
Collings, W., El-Sayegh, Z., Ren, J., & El-Gindy, M. (2024). Modelling of Truck Tire–Rim Slip on Sandy Loam Using Advanced Computational Techniques. Geotechnics, 4(1), 229-241. https://doi.org/10.3390/geotechnics4010012
Vancouver
Collings W, El-Sayegh Z, Ren J, El-Gindy M. Modelling of Truck Tire–Rim Slip on Sandy Loam Using Advanced Computational Techniques. Geotechnics. 2024;4(1):229-241. doi:10.3390/geotechnics4010012
BibTeX
@article{Collings2024,
author = {Collings, William and El-Sayegh, Zeinab and Ren, Jing and El-Gindy, Moustafa},
title = {Modelling of Truck Tire–Rim Slip on Sandy Loam Using Advanced Computational Techniques},
journal = {Geotechnics},
year = {2024},
volume = {4},
number = {1},
pages = {229--241},
doi = {10.3390/geotechnics4010012}
}
EUVIMED