EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Thermomechanical Performance Assessment of Sustainable Buildings’ Insulating Materials under Accelerated Ageing Conditions

Ana Dora Rodrigues Pontinha iD, Johanna Mäntyneva, Paulo Santos iD, Luísa Durães iD

Gels · 18.03.2023 · 9 (3) · 241

DOI: 10.3390/gels9030241 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Gels, online erschienen am 18.03.2023. Verfasst von Ana Dora Rodrigues Pontinha und 3 weiteren Autor:innen. Beteiligte Einrichtung: University of Coimbra, CIEPQPF, Department of Chemical Engineering, 3004-531 Coimbra, Portugal. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundação para a Ciência e Tecnologia, European Regional Development Fund (ERDF), FCT—Fundação para a Ciência e Tecnologia.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The reliable characterization of insulation materials in relevant environmental conditions is crucial, since it strongly influences the performance (e.g., thermal) of building elements. In fact, their properties may vary with the moisture content, temperature, ageing degradation, etc. Therefore, in this work, the thermomechanical behaviour of different materials was compared when subjected to accelerated ageing. Insulation materials that use recycled rubber in their composition were studied, along with others for comparison: heat-pressed rubber, rubber_cork composites, aerogel_rubber composite (developed by the authors), silica aerogel, and extruded polystyrene. The ageing cycles comprised dry-heat, humid-heat, and cold conditions as the stages, during cycles of 3 and 6 weeks. The materials’ properties after ageing were compared with the initial values. Aerogel-based materials showed superinsulation behaviour and good flexibility due to their very high porosity and reinforcement with fibres. Extruded polystyrene also had a low thermal conductivity but exhibited permanent deformation under compression. In general, the ageing conditions led to a very slight increase in the thermal conductivity, which vanished after drying of the samples in an oven, and to a decrease in Young’s moduli.

Schlagwörter

Stichwörter der Autor:innen

Young’s modulusageingperformance assessmentthermal conductivitythermal insulation materials

Autor:innen und Institutionen

  • University of Coimbra, CIEPQPF, Department of Chemical Engineering, 3004-531 Coimbra, Portugal.
  • Häme University of Applied Sciences, HAMK Tech Research Unit, 13100 Hämeenlinna, Finland.
  • University of Coimbra, ISISE, ARISE, Department of Civil Engineering, 3004-531 Coimbra, Portugal.

ORCID-Profile: Ana Dora Rodrigues Pontinha, Paulo Santos, Luísa Durães

Förderung

  • Fundação para a Ciência e Tecnologia
  • European Regional Development Fund (ERDF)
  • FCT—Fundação para a Ciência e Tecnologia

Zitieren

APA

Pontinha, A. D. R., Mäntyneva, J., Santos, P., & Durães, L. (2023). Thermomechanical Performance Assessment of Sustainable Buildings’ Insulating Materials under Accelerated Ageing Conditions. Gels, 9(3), 241. https://doi.org/10.3390/gels9030241

Vancouver

Pontinha ADR, Mäntyneva J, Santos P, Durães L. Thermomechanical Performance Assessment of Sustainable Buildings’ Insulating Materials under Accelerated Ageing Conditions. Gels. 2023;9(3):241. doi:10.3390/gels9030241

BibTeX
@article{Pontinha2023,
  author = {Pontinha, Ana Dora Rodrigues and Mäntyneva, Johanna and Santos, Paulo and Durães, Luísa},
  title = {Thermomechanical Performance Assessment of Sustainable Buildings’ Insulating Materials under Accelerated Ageing Conditions},
  journal = {Gels},
  year = {2023},
  volume = {9},
  number = {3},
  pages = {241},
  doi = {10.3390/gels9030241}
}
Kostenlos starten →