EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental Investigation of Friction Factor Performance in Additively Manufactured PCHE-Type Semicircular Channels with Corner Filleting

Lam Lam, Yifan Yang, Jiahang Chen, Lap Mou Tam, Afshin J. Ghajar

Fluids · 07.06.2026 · 11 (6) · 142

DOI: 10.3390/fluids11060142 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Fluids, online erschienen am 07.06.2026. Verfasst von Lam Lam und 4 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Macao Science and Technology Development Fund, and the Ministry of Science and Technology of China, Institute for the Development and Quality, Macau.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing (AM) introduces surface roughness that is much larger than that in chemically etched printed circuit heat exchanger (PCHE) channels, limiting the applicability of established design correlation. In this study, four selective laser melting (SLM) 3D-printed stainless steel test sections were tested, namely two semicircular and two rounded-edge semicircular channels, at hydraulic diameters of 2 mm and 4 mm. Water was used as the test fluid in the experiment, with a Reynolds number ranging from 500 to 7000 and wall heat flux ranging from 20 to 90 kW/m2. Scanning electron microscopy image characterization shows significant material accumulation concentrated at the rounded edges of the as-built channels. The experimental results show that for the entire flow regime, the printed rounded edge increases the friction factor by approximately 9% for 2 mm and 4 mm channels. The filleting design would increase the effective hydraulic roughness in small-diameter AM channels. The SLM 3D-printed rougher channel has a lower transition Reynolds number and higher turbulent friction factors compared to the etching channel. The data were compared with existing smooth PCHE channel data and rough AM mini-channel correlation, and two empirical correlations were developed for SLM 3D-printed mini-channels for transition and turbulent regimes.

Förderung

  • Macao Science and Technology Development Fund
  • and the Ministry of Science and Technology of China
  • Institute for the Development and Quality, Macau

Zitieren

APA

Lam, L., Yang, Y., Chen, J., Tam, L. M., & Ghajar, A. J. (2026). Experimental Investigation of Friction Factor Performance in Additively Manufactured PCHE-Type Semicircular Channels with Corner Filleting. Fluids, 11(6), 142. https://doi.org/10.3390/fluids11060142

Vancouver

Lam L, Yang Y, Chen J, Tam LM, Ghajar AJ. Experimental Investigation of Friction Factor Performance in Additively Manufactured PCHE-Type Semicircular Channels with Corner Filleting. Fluids. 2026;11(6):142. doi:10.3390/fluids11060142

BibTeX
@article{Lam2026,
  author = {Lam, Lam and Yang, Yifan and Chen, Jiahang and Tam, Lap Mou and Ghajar, Afshin J.},
  title = {Experimental Investigation of Friction Factor Performance in Additively Manufactured PCHE-Type Semicircular Channels with Corner Filleting},
  journal = {Fluids},
  year = {2026},
  volume = {11},
  number = {6},
  pages = {142},
  doi = {10.3390/fluids11060142}
}
Kostenlos starten →