EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Evaluation of Peripheral Milling and Abrasive Water Jet Cutting in CFRP Manufacturing: Analysis of Defects and Surface Quality

Alejandro Sambruno, Álvaro Gómez-Parra, Pablo Márquez, Iñaki Tellaeche-Herrera, Moisés Batista

Fibers · 25.09.2024 · 12 (10) · 78

DOI: 10.3390/fib12100078 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Fibers, online erschienen am 25.09.2024. Verfasst von Alejandro Sambruno und 4 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The use of carbon fiber reinforced polymers (CFRP) is crucial in industries, such as aerospace, automotive, and marine, due to their excellent strength-to-weight ratio and corrosion resistance. However, machining CFRP is challenging due to its abrasive nature, which can cause premature tool wear. Some of the commonly used processes for machining these materials are dry milling and abrasive water jet machining (AWJM), which offer the best alternatives from an environmental point of view. This article presents an analysis of the defects and surface quality obtained in CFRP after machining by AWJM and milling. For this purpose, combinations of relevant parameters have been chosen for each process: cutting speed and tool wear in milling and traverse feed rate and hydraulic pressure in AWJM. The results obtained have been evaluated from two points of view: macroscopically, through the evaluation of delamination, and microscopically, through the study of the roughness in terms of Ra. Furthermore, a discussion on functional, environmental, economic, and social terms has been made between both processes. In summary, each machining process generates a specific type of delamination: Type II in milling and Type I in AWJM. In addition, the best Ra results are obtained for pressures of 1200 bar in AWJM.

Zitieren

APA

Sambruno, A., Gómez-Parra, Á., Márquez, P., Tellaeche-Herrera, I., & Batista, M. (2024). Evaluation of Peripheral Milling and Abrasive Water Jet Cutting in CFRP Manufacturing: Analysis of Defects and Surface Quality. Fibers, 12(10), 78. https://doi.org/10.3390/fib12100078

Vancouver

Sambruno A, Gómez-Parra Á, Márquez P, Tellaeche-Herrera I, Batista M. Evaluation of Peripheral Milling and Abrasive Water Jet Cutting in CFRP Manufacturing: Analysis of Defects and Surface Quality. Fibers. 2024;12(10):78. doi:10.3390/fib12100078

BibTeX
@article{Sambruno2024,
  author = {Sambruno, Alejandro and Gómez-Parra, Álvaro and Márquez, Pablo and Tellaeche-Herrera, Iñaki and Batista, Moisés},
  title = {Evaluation of Peripheral Milling and Abrasive Water Jet Cutting in CFRP Manufacturing: Analysis of Defects and Surface Quality},
  journal = {Fibers},
  year = {2024},
  volume = {12},
  number = {10},
  pages = {78},
  doi = {10.3390/fib12100078}
}
Kostenlos starten →