EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Heating Rate during Thermal Modification in Steam Atmosphere: Influence on the Properties of Maple and Ash Wood

Goran Milić, Nebojša Todorović, Marko Veizović, Ranko Popadić

Forests · 18.01.2023 · 14 (2) · 189

DOI: 10.3390/f14020189 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Forests, online erschienen am 18.01.2023. Verfasst von Goran Milić und 3 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Education, Science and Technological Development of the Republic of Serbia.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study aimed to compare two thermal modification (TM) schedules—with short and long heating phases—and their influence on the properties of maple (Acer pseudoplatanus L.) and ash (Fraxinus excelsior L.) wood. Two TM runs were conducted in industrial conditions (open system, steam atmosphere; substantially longer method compared to the processes usually described in the literature), with the same peak phase (200 °C, 3 h), but with different heating rates—slow (1.1 °C/h) and fast (2.5 °C/h). The results revealed that both TMs significantly reduced hygroscopicity and swelling of wood, but the influence of slow heating rate—through prolonged exposure of wood to relatively high temperatures—on dimensional stability was more pronounced. The modulus of elasticity, compressive strength and Brinell hardness remained mostly unchanged after TM (except for fast-modified maple), while the modulus of rupture was strongly reduced by TM in both species. It is assumed—at least in the case of maple wood—that a combination of initial moisture content above 8% and fast heating rate during TM can cause more intensive degradation of wood polymers. Relatively small differences in colour between slow- and fast-modified wood were found. The results confirmed the hypothesis that the heating phase is an important part of the TM schedule, and it can directly affect (together with peak temperature and time) certain wood properties.

Förderung

  • Ministry of Education, Science and Technological Development of the Republic of Serbia

Zitieren

APA

Milić, G., Todorović, N., Veizović, M., & Popadić, R. (2023). Heating Rate during Thermal Modification in Steam Atmosphere: Influence on the Properties of Maple and Ash Wood. Forests, 14(2), 189. https://doi.org/10.3390/f14020189

Vancouver

Milić G, Todorović N, Veizović M, Popadić R. Heating Rate during Thermal Modification in Steam Atmosphere: Influence on the Properties of Maple and Ash Wood. Forests. 2023;14(2):189. doi:10.3390/f14020189

BibTeX
@article{Mili2023,
  author = {Milić, Goran and Todorović, Nebojša and Veizović, Marko and Popadić, Ranko},
  title = {Heating Rate during Thermal Modification in Steam Atmosphere: Influence on the Properties of Maple and Ash Wood},
  journal = {Forests},
  year = {2023},
  volume = {14},
  number = {2},
  pages = {189},
  doi = {10.3390/f14020189}
}
Kostenlos starten →