Reconfigurable Switched Reluctance Motor Drive for Electric Vehicles with Grid Charging and Vehicle-to-Grid Operations
Energies · 07.11.2026 · 19 (21) · 5340
DOI: 10.3390/en19215340 ↗Kurz gefasst
Fachartikel in der Zeitschrift Energies, online erschienen am 07.11.2026. Verfasst von Sreeram Krishnamoorthy und 3 weiteren Autor:innen. Die Arbeit nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Universitat Politècnica de València, AMRITA Seed Grant.
Abstract (Originalsprache)
Electric vehicles (EVs) have sparked global awakening in their ability to lower greenhouse gas emissions and reliance on fossil fuels. The traction motor and associated electronic power converters have a strong impact on the performance and reliability of EVs. Switched reluctance motors (SRMs) have emerged as a substitute for EVs owing to their simple and robust construction, devoid of rotor windings and permanent magnets, high fault tolerance, wide speed range, and resilience to rugged operating conditions. Their applicability for electric traction has been impaired by torque density, excessive torque ripples, and acoustic noise. Conventional EVs use two converters, each for charging and traction, which increase the vehicle’s cost, weight, and volume. Footprints of contemporary integrated battery charger (IBC) configurations are dissuaded by high component count, complex control mechanisms, and restrictive bidirectional operation. This paper proposes a multimode, reconfigurable IBC–integrated switched reluctance motor (SRM) drive, operable in traction, Grid-to-Vehicle (G2V), and Vehicle-to-Grid (V2G) modes. The proposed configuration reuses the SRM phase windings as grid-side inductors during G2V and V2G modes, thereby eliminating a separate dedicated grid-side charging inductor stage and extra charging power conversion stage. The simulation model employs a three-phase 6/4 SRM, whereas the laboratory prototype employs a three-phase 12/8 SRM. The proposed reconfigurable integrated battery charger was evaluated in traction mode using sliding-mode control, model-predictive control, and proportional–integral hysteresis control. For a 1500 rpm speed reference, sliding-mode control achieved the best dynamic response, reducing the rise time and settling times to 14 s and 24 s, respectively, compared with 47 s and 78 s for proportional–integral hysteresis control. It reduced the torque ripple coefficient from 1.31 to 0.020, while model-predictive control achieved 0.0168, with an increased algorithmic computational burden associated with online prediction and optimization. Experimental results establish effective operation in traction, G2V, and V2G modes under the tested laboratory conditions, with a measured power factor of approximately 0.90 and current THD of 3.3% in G2V and 5.2% in V2G modes.
Förderung
- Universitat Politècnica de València
- AMRITA Seed Grant
Zitieren
APA
Krishnamoorthy, S., Panikkar, P. P. K., Rodríguez-García, J., & Álvarez-Bel, C. (2026). Reconfigurable Switched Reluctance Motor Drive for Electric Vehicles with Grid Charging and Vehicle-to-Grid Operations. Energies, 19(21), 5340. https://doi.org/10.3390/en19215340
Vancouver
Krishnamoorthy S, Panikkar PPK, Rodríguez-García J, Álvarez-Bel C. Reconfigurable Switched Reluctance Motor Drive for Electric Vehicles with Grid Charging and Vehicle-to-Grid Operations. Energies. 2026;19(21):5340. doi:10.3390/en19215340
BibTeX
@article{Krishnamoorthy2026,
author = {Krishnamoorthy, Sreeram and Panikkar, Preetha Parakkat Kesava and Rodríguez-García, Javier and Álvarez-Bel, Carlos},
title = {Reconfigurable Switched Reluctance Motor Drive for Electric Vehicles with Grid Charging and Vehicle-to-Grid Operations},
journal = {Energies},
year = {2026},
volume = {19},
number = {21},
pages = {5340},
doi = {10.3390/en19215340}
}
EUVIMED