Numerical Investigation on the Thermal-Hydraulic Performance of Molten Salt in Internal Helically Finned Tubes
Energies · 31.07.2026 · 19 (15) · 3599
DOI: 10.3390/en19153599 ↗Kurz gefasst
Fachartikel in der Zeitschrift Energies, online erschienen am 31.07.2026. Verfasst von Taotao Huang und 5 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key R&D Program of China.
Abstract (Originalsprache)
Molten salts have attracted considerable attention as heat transfer and thermal storage media in high-temperature energy systems, including concentrating solar power systems, advanced heat exchangers, and nuclear-related thermal systems. However, their relatively low thermal conductivity, high Prandtl number, and strong temperature-dependent viscosity may limit convective heat transfer performance and increase the difficulty of thermal-hydraulic design. Internally helically finned tubes have been widely used as passive heat transfer enhancement structures in conventional thermal systems, but their applicability to high-temperature molten-salt flows remains insufficiently understood. In this study, a three-dimensional numerical model was developed to investigate the thermal-hydraulic performance of a low-melting-point quaternary nitrate salt flowing through internally helically finned tubes. The effects of fin pitch, fin height, and helix angle were systematically examined over a Reynolds number range of 14,000–26,000. The results show that decreasing the fin pitch and increasing the helix angle enhance near-wall flow disturbance and improve convective heat transfer, while also increasing the pressure drop. The fin height exhibits a more pronounced trade-off effect: although larger fins increase the heat transfer coefficient, excessive fin height causes a substantial hydraulic penalty and weakens the overall performance. Based on the Performance Evaluation Criterion, the configuration with a fin pitch of 1.4 mm, fin height of 0.4 mm, and helix angle of 30° achieves the best overall thermal-hydraulic performance within the investigated parameter range, with a maximum PEC of 2.14. Compared with representative enhanced-tube configurations reported for molten-salt heat transfer, the internally helically finned tube shows competitive comprehensive performance. This work provides a numerical assessment of the feasibility and design sensitivity of internally helically finned tubes for molten-salt heat exchangers and offers useful guidance for the optimization of high-temperature thermal energy systems.
Förderung
- National Key R&D Program of China
Zitieren
APA
Huang, T., Chen, J., Ling, Z., Fang, X., Zhang, C., & Zhang, Z. (2026). Numerical Investigation on the Thermal-Hydraulic Performance of Molten Salt in Internal Helically Finned Tubes. Energies, 19(15), 3599. https://doi.org/10.3390/en19153599
Vancouver
Huang T, Chen J, Ling Z, Fang X, Zhang C, Zhang Z. Numerical Investigation on the Thermal-Hydraulic Performance of Molten Salt in Internal Helically Finned Tubes. Energies. 2026;19(15):3599. doi:10.3390/en19153599
BibTeX
@article{Huang2026,
author = {Huang, Taotao and Chen, Junjie and Ling, Ziye and Fang, Xiaoming and Zhang, Cancan and Zhang, Zhengguo},
title = {Numerical Investigation on the Thermal-Hydraulic Performance of Molten Salt in Internal Helically Finned Tubes},
journal = {Energies},
year = {2026},
volume = {19},
number = {15},
pages = {3599},
doi = {10.3390/en19153599}
}
EUVIMED