Parameter Optimization of Tunnel Oxide Passivated Back Contact (TBC) Solar Cells
Energies · 25.03.2026 · 19 (7) · 1612
DOI: 10.3390/en19071612 ↗Kurz gefasst
Fachartikel in der Zeitschrift Energies, online erschienen am 25.03.2026. Verfasst von Yang Chen und 3 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the National Natural Science Foundation of China https://ror.org/01h0zpd94.
Abstract (Originalsprache)
Traditional simulation work often starts from the study of the impact of a single factor on device performance to obtain the optimal value of that factor and then regards the combination of the optimal values of each factor as the optimization condition. Obviously, this approach ignores the impacts of the interactions among factors on device performance. To address this issue, this paper uses Quokka3 v2.6.0 and JMP Pro 17.0.0 to perform device simulation and parameter optimization research on tunnel oxide passivated back contact (TBC) solar cells. First, Quokka3 was employed to investigate the effects of silicon wafer properties, rear-side passivation and contact characteristics, and rear-side geometry on the performance of TBC solar cells. Subsequently, a total of 625 simulations were performed by using Quokka3 with four factors (wafer thickness, wafer resistivity, P/N ratio, and pitch) at five levels. Finally, JMP Pro was used to analyze the simulation results statistically. It was found that the pitch, P/N ratio, quadratic power terms, quadratic interaction terms except the interaction between wafer thickness and resistivity, cubic power terms, and some cubic interaction terms all have significant impact on power conversion efficiency (PCE). JMP Pro predicted that the TBC solar cell could achieve the maximum PCE of 26.784% under the conditions of wafer thickness = 143.25 μm, wafer resistivity = 1.09 Ω·cm, P/N ratio = 1.94, and pitch = 380 μm.
Förderung
- the National Natural Science Foundation of China https://ror.org/01h0zpd94
Zitieren
APA
Chen, Y., Chen, Y., Ai, B., & Zhou, Y. (2026). Parameter Optimization of Tunnel Oxide Passivated Back Contact (TBC) Solar Cells. Energies, 19(7), 1612. https://doi.org/10.3390/en19071612
Vancouver
Chen Y, Chen Y, Ai B, Zhou Y. Parameter Optimization of Tunnel Oxide Passivated Back Contact (TBC) Solar Cells. Energies. 2026;19(7):1612. doi:10.3390/en19071612
BibTeX
@article{Chen2026,
author = {Chen, Yang and Chen, Yongqiang and Ai, Bin and Zhou, Yecheng},
title = {Parameter Optimization of Tunnel Oxide Passivated Back Contact (TBC) Solar Cells},
journal = {Energies},
year = {2026},
volume = {19},
number = {7},
pages = {1612},
doi = {10.3390/en19071612}
}
EUVIMED