EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Three-Dimensionally Printed Metal-Coated Flow-Field Plate for Lightweight Polymer Electrolyte Membrane Fuel Cells

Dasol Kim, Geonhwi Kim, Juho Na, Hyeok Kim, Jaeyeon Kim, Guyoung Cho, Taehyun Park

Energies · 20.03.2025 · 18 (6) · 1533

DOI: 10.3390/en18061533 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Energies, online erschienen am 20.03.2025. Verfasst von Dasol Kim und 6 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and ICT.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the potential for affordable and lightweight polymer electrolyte membrane fuel cells (PEMFCs) using lightweight flow-field plates, also referred to as bipolar plates. A comparative analysis was conducted on the performance of metal-coated and uncoated three-dimensional (3D)-printed flow-field plates, as well as that of a conventional graphite flow-field plate. The fabrication of these lightweight flow-field plates involved the application of sputtering and 3D printing technologies. The polarization curves and corresponding electrochemical impedance spectra of PEMFCs with metal-coated 3D-printed, uncoated 3D-printed, and graphite flow-field plates were measured. The results demonstrate that the metal-coated 3D-printed flow-field plate exhibits a gravimetric power density of 5.21 mW/g, while the graphite flow-field plate registers a value of 2.78 mW/g, representing an 87.4% improvement in gravimetric power density for the metal-coated 3D-printed flow-field plate compared to the graphite flow-field plate. These findings suggest the feasibility of reducing the weight of PEMFCs using metal-coated 3D-printed flow-field plates.

Förderung

  • Ministry of Science and ICT

Zitieren

APA

Kim, D., Kim, G., Na, J., Kim, H., Kim, J., Cho, G., & Park, T. (2025). Three-Dimensionally Printed Metal-Coated Flow-Field Plate for Lightweight Polymer Electrolyte Membrane Fuel Cells. Energies, 18(6), 1533. https://doi.org/10.3390/en18061533

Vancouver

Kim D, Kim G, Na J, Kim H, Kim J, Cho G, et al. Three-Dimensionally Printed Metal-Coated Flow-Field Plate for Lightweight Polymer Electrolyte Membrane Fuel Cells. Energies. 2025;18(6):1533. doi:10.3390/en18061533

BibTeX
@article{Kim2025,
  author = {Kim, Dasol and Kim, Geonhwi and Na, Juho and Kim, Hyeok and Kim, Jaeyeon and Cho, Guyoung and Park, Taehyun},
  title = {Three-Dimensionally Printed Metal-Coated Flow-Field Plate for Lightweight Polymer Electrolyte Membrane Fuel Cells},
  journal = {Energies},
  year = {2025},
  volume = {18},
  number = {6},
  pages = {1533},
  doi = {10.3390/en18061533}
}
Kostenlos starten →