Effects of Pre-Injection Strategy on Combustion Characteristics of Ammonia/Diesel Dual-Fuel Compression Ignition Mode
Energies · 21.11.2023 · 16 (23) · 7687
DOI: 10.3390/en16237687 ↗Kurz gefasst
Fachartikel in der Zeitschrift Energies, online erschienen am 21.11.2023. Verfasst von Lianmei Guo und 7 weiteren Autor:innen. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Shanxi Province Science and Technology Major Special Project.
Abstract (Originalsprache)
As a zero-carbon clean fuel, the use of ammonia in internal combustion engines is of great significance to achieve the “two-carbon” goal. This paper investigates the effect of the ammonia energy ratio and diesel injection timing on combustion and emissions. Based on Computational fluid dynamics (CFD) and the simulation analysis software, Converge, three-dimensional modeling is carried out for a direct injection diesel engine with a Compression Ignition (CI) mode. Under the initial full-load conditions of 1200 r/min, the engine simulation was calculated. The results show that the peak cylinder pressure increases and then decreases as the ammonia energy ratio increases, the ignition delay time increases, and the CO2 and N2O emissions decrease. With pre-injection, the peak cylinder pressure increases at the same energy ratio and the combustion stage advances, resulting in improved indicated thermal efficiency. In comparison to the pure diesel mode, the pre-injection strategy shows an obvious reduction in greenhouse gas (GHG) emissions with a decrease of 40.9% by adjusting the injection timing, while the single injection strategy shows a reduction of 36.5%. The soot emission peak occurs in the diesel-only mode with 98.13% and 99.6% reductions in emissions under single and pre-injection, respectively. The ammonia–diesel dual-fuel (ADDF) engine with an ammonia-to-energy ratio of 70% and optimized ammonia and diesel injection timing significantly reduces the NH3 emissions and GHG emissions by 69.34%.
Förderung
- Shanxi Province Science and Technology Major Special Project
Zitieren
APA
Guo, L., Zhu, J., Fu, L., Li, Z., Liu, F., Wang, Z., Liu, X., & Dong, Q. (2023). Effects of Pre-Injection Strategy on Combustion Characteristics of Ammonia/Diesel Dual-Fuel Compression Ignition Mode. Energies, 16(23), 7687. https://doi.org/10.3390/en16237687
Vancouver
Guo L, Zhu J, Fu L, Li Z, Liu F, Wang Z, et al. Effects of Pre-Injection Strategy on Combustion Characteristics of Ammonia/Diesel Dual-Fuel Compression Ignition Mode. Energies. 2023;16(23):7687. doi:10.3390/en16237687
BibTeX
@article{Guo2023,
author = {Guo, Lianmei and Zhu, Jianjun and Fu, Laibin and Li, Zhixin and Liu, Fanfan and Wang, Zilin and Liu, Xiangyang and Dong, Qinqiang},
title = {Effects of Pre-Injection Strategy on Combustion Characteristics of Ammonia/Diesel Dual-Fuel Compression Ignition Mode},
journal = {Energies},
year = {2023},
volume = {16},
number = {23},
pages = {7687},
doi = {10.3390/en16237687}
}
EUVIMED