EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Quantitative Trade-Off Evaluation of Hardened DFFs in 130 nm ProASIC3 Flash-Based FPGAs Under Wide-LET Heavy-Ion Irradiation

Jinlong Ma, Weike Liu, Wenxun Wei, Xin Chen, Danfeng Qiu, Zongguang Yu, Daiyin Zhu

Electronics · 19.11.2026 · 15 (22) · 5390

DOI: 10.3390/electronics15225390 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 19.11.2026. Verfasst von Jinlong Ma und 6 weiteren Autor:innen. Die Arbeit nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Single-event upset (SEU) hardening of native D flip-flops (DFFs) in flash-based field-programmable gate arrays (FPGAs) lacks unified experimental conditions and quantitative selection criteria; this work implements six DFF structures on one and the same A3PE3000 chip as identical dual 243-bit shift-register test chains. These include an unhardened baseline DFF (BL-DFF), a conventional triple-modular-redundancy DFF (TMR-DFF), three delay-filtering TMR-DFF variants (DF-TMR-DFF), and one dual-path combinational-logic-replica TMR-DFF (DCLR-TMR-DFF). Realized DF-TMR-DFF filtering windows are set by on-chip process–voltage–temperature (PVT) calibration rather than nominal design values. Six heavy-ion species are used, with linear energy transfer (LET) of 4.4–82.06 MeV·cm2/mg, and irradiation data are processed through a five-stage procedure to remove terminal output-stage single-event transients (SETs) and retain genuine bit-cell upsets. All cross-sections are normalized per logic bit (one complete instance) rather than per storage cell. At the highest LET, the DCLR-TMR-DFF achieves the lowest cross-section of 8.23 × 10−10 cm2/bit, approximately 1/145 and 1/27 of the BL-DFF and TMR-DFF cross-sections, respectively; the DF-TMR-DFF cross-sections decrease from 1.58 × 10−8 to 2.06 × 10−9 cm2/bit as the filtering windows widen. The proposed analytical model shows that which of the DF-TMR-DFF and the DCLR-TMR-DFF has the lower per-bit VersaTile overhead depends on the delay-stage count relative to the combinational-to-sequential resource ratio ρ0, with measured per-bit overheads from 11 (BL-DFF) to 37 (DCLR-TMR-DFF) VersaTiles. Post-layout static timing analysis (STA) of standalone projects gives maximum frequencies of 59.034, 52.384, and 43.092 MHz for BL-DFF, TMR-DFF, and DCLR-TMR-DFF, and 40.827–32.083 MHz for the DF-TMR-DFF variants, whose radiation-hardness gain comes at the expense of timing performance. No structure is optimal across all three dimensions, and trade-offs are required in design. A four-tier engineering selection boundary is established for 130 nm ProASIC3 space circuits. All TMR-based structures share an inherent single-point vulnerability at the terminal three-input majority voter.

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Ma, J., Liu, W., Wei, W., Chen, X., Qiu, D., Yu, Z., & Zhu, D. (2026). Quantitative Trade-Off Evaluation of Hardened DFFs in 130 nm ProASIC3 Flash-Based FPGAs Under Wide-LET Heavy-Ion Irradiation. Electronics, 15(22), 5390. https://doi.org/10.3390/electronics15225390

Vancouver

Ma J, Liu W, Wei W, Chen X, Qiu D, Yu Z, et al. Quantitative Trade-Off Evaluation of Hardened DFFs in 130 nm ProASIC3 Flash-Based FPGAs Under Wide-LET Heavy-Ion Irradiation. Electronics. 2026;15(22):5390. doi:10.3390/electronics15225390

BibTeX
@article{Ma2026,
  author = {Ma, Jinlong and Liu, Weike and Wei, Wenxun and Chen, Xin and Qiu, Danfeng and Yu, Zongguang and Zhu, Daiyin},
  title = {Quantitative Trade-Off Evaluation of Hardened DFFs in 130 nm ProASIC3 Flash-Based FPGAs Under Wide-LET Heavy-Ion Irradiation},
  journal = {Electronics},
  year = {2026},
  volume = {15},
  number = {22},
  pages = {5390},
  doi = {10.3390/electronics15225390}
}
Kostenlos starten →