EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Adaptive Digital Control Architecture for Multi-Agent Industrial Electroplating Lines: A Modular Microcontroller-Based Approach

Nebojša Andrijević, Zoran Lovreković, Vladimir Đokić, Jasmina Perišić, Marina Milovanović

Electronics · 10.04.2026 · 15 (8) · 1588

DOI: 10.3390/electronics15081588 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 10.04.2026. Verfasst von Nebojša Andrijević und 4 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a deterministic embedded control architecture for an industrial electroplating line. The validated system includes two autonomous trolleys, 18 station-aligned process positions, shared-track motion, and redundant grouped baths. The proposed controller addresses the limitations of rigid sequential automation by combining asynchronous finite-state trolley execution, runtime allocation of equivalent technological stations, dwell-time-preserving retrieval, distributed thermal supervision, and layered fail-safe protection within a single ATmega2560-based implementation. The core contribution is the integration of virtual process groups and temporal FIFO logic into a compact plant-side embedded controller. This enables adaptive bath selection and process-completion-based retrieval without reliance on a real-time operating system or a computationally heavy supervisory runtime. The architecture also incorporates predictive pre-start validation, runtime software arbitration, hardware-wired interlocks, binary-coded trolley positioning, and a distributed 1-Wire thermal measurement network. Validation was performed in a controller-centered hardware-in-the-loop representation of an 18-station zinc electroplating line. Over a 100-batch horizon, the proposed architecture reduced makespan from 1642 min to 1244 min, corresponding to a 24.2% throughput improvement. Average trolley idle time decreased from 18.4 min/batch to 4.1 min/batch. Grouped-bath utilization increased from 64% to 91%, while tracked bottleneck incidents decreased from 18 to 2. These results show that adaptive, resource-aware, and safety-layered electroplating control can be realized effectively on a compact embedded platform in an industry-representative HIL setting, while preserving dwell-time integrity and controller-level safety invariants.

Zitieren

APA

Andrijević, N., Lovreković, Z., Đokić, V., Perišić, J., & Milovanović, M. (2026). Adaptive Digital Control Architecture for Multi-Agent Industrial Electroplating Lines: A Modular Microcontroller-Based Approach. Electronics, 15(8), 1588. https://doi.org/10.3390/electronics15081588

Vancouver

Andrijević N, Lovreković Z, Đokić V, Perišić J, Milovanović M. Adaptive Digital Control Architecture for Multi-Agent Industrial Electroplating Lines: A Modular Microcontroller-Based Approach. Electronics. 2026;15(8):1588. doi:10.3390/electronics15081588

BibTeX
@article{Andrijevi2026,
  author = {Andrijević, Nebojša and Lovreković, Zoran and Đokić, Vladimir and Perišić, Jasmina and Milovanović, Marina},
  title = {Adaptive Digital Control Architecture for Multi-Agent Industrial Electroplating Lines: A Modular Microcontroller-Based Approach},
  journal = {Electronics},
  year = {2026},
  volume = {15},
  number = {8},
  pages = {1588},
  doi = {10.3390/electronics15081588}
}
Kostenlos starten →