EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Variable Cutoff Frequency Low-Pass Attenuator Based on Memristor with Sharp Roll-Off Characteristic

Jie Lian, Xingyu Liao, Junjie Wang, Shuang Liu, Yan Wang, Yang Liu

Electronics · 11.03.2026 · 15 (6) · 1164

DOI: 10.3390/electronics15061164 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 11.03.2026. Verfasst von Jie Lian und 5 weiteren Autor:innen. Die Arbeit nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, National Key Laboratory of Integrated Circuits and Microsystems, Scientific Research Fundation of the Education Department of Sichuan Province, China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Frequency-selective attenuation is widely needed in integrated analog front-ends, yet conventional on-chip RC low-pass filters occupy unfeasibly large silicon areas for low-frequency cutoffs and inherently introduce cumulative phase lag. Motivated by the nonlinear, frequency-dependent state evolution of memristive devices, this work experimentally demonstrates a highly compact, capacitor-free memristor–resistor network that functions as a variable-cutoff, zero-phase-lag resistive attenuator. An Au/HfO2/Au memristor (15 µm × 15 µm) is connected in series with a load resistor and characterized over a wide frequency range. By leveraging the finite time constant of internal ionic drift, the attenuation bandwidth is strictly programmable via the device’s initial resistance. Cutoff frequencies of approximately 10 Hz, 1 kHz, and 10 kHz are achieved for initial resistances of 400 kΩ±30 kΩ, 300 kΩ±30 kΩ, and 200 kΩ±30 kΩ, respectively. Remarkably, the nonlinear state-switching mechanism enables a steep post-cutoff attenuation rate approaching −60 dB/dec—equivalent to a cascaded third-order RC network—using only a single nanoscale device. Rather than functioning as a strictly linear time-invariant (LTI) filter, the proposed circuit operates as a state-adaptive edge-processor. Its inherent amplitude-dependent dynamics and total absence of reactive poles make it exceptionally suited for highly specialized, area-constrained applications, including zero-phase closed-loop noise suppression, frequency-to-amplitude conversion, and amplitude-aware event-driven sensory preprocessing.

Förderung

  • National Natural Science Foundation of China
  • National Key Laboratory of Integrated Circuits and Microsystems
  • Scientific Research Fundation of the Education Department of Sichuan Province, China

Zitieren

APA

Lian, J., Liao, X., Wang, J., Liu, S., Wang, Y., & Liu, Y. (2026). Variable Cutoff Frequency Low-Pass Attenuator Based on Memristor with Sharp Roll-Off Characteristic. Electronics, 15(6), 1164. https://doi.org/10.3390/electronics15061164

Vancouver

Lian J, Liao X, Wang J, Liu S, Wang Y, Liu Y. Variable Cutoff Frequency Low-Pass Attenuator Based on Memristor with Sharp Roll-Off Characteristic. Electronics. 2026;15(6):1164. doi:10.3390/electronics15061164

BibTeX
@article{Lian2026,
  author = {Lian, Jie and Liao, Xingyu and Wang, Junjie and Liu, Shuang and Wang, Yan and Liu, Yang},
  title = {Variable Cutoff Frequency Low-Pass Attenuator Based on Memristor with Sharp Roll-Off Characteristic},
  journal = {Electronics},
  year = {2026},
  volume = {15},
  number = {6},
  pages = {1164},
  doi = {10.3390/electronics15061164}
}
Kostenlos starten →