EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Construction of a Machining Process Knowledge Graph and Its Application in Process Route Recommendation

Liang Li, Jiaxing Liang, Chunlei Li, Zhe Liu, Yingying Wei, Zeyu Ji

Electronics · 07.08.2025 · 14 (15) · 3156

DOI: 10.3390/electronics14153156 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 07.08.2025. Verfasst von Liang Li und 5 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 31 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Key Research and Development Program of Shaanxi.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper proposes a knowledge graph (KG) construction method for a part machining process in response to the low degree of structuring of historical process data association relationships within the enterprise in the field of part machining, which makes it difficult to reuse effectively. The part types are mainly shafts, gears, boxes and other common parts. First, the schema layer of the process knowledge graph was constructed using a top-down approach. Second, deep learning techniques were employed for entity extraction, while knowledge fusion and ontology relationship establishment methods were combined to build the data layer of the process knowledge graph (PKG) from the bottom up. Third, the mapping between the schema layer and data layer was implemented in the Neo4j graph database. Based on the constructed process KG, process route recommendation and rapid retrieval of process information were thus accomplished. Finally, a shaft part was used as the target part to verify the effectiveness of the proposed method. In over 300 trials, the similarity-based recommendation model achieved a hit rate of 91.7% (the target part’s route appeared in the recommended list in 91.7% of cases). These results indicate that the proposed machining PKG construction is feasible and can assist in process planning, potentially improving the efficiency of retrieving and reusing machining knowledge.

Förderung

  • Key Research and Development Program of Shaanxi

Zitieren

APA

Li, L., Liang, J., Li, C., Liu, Z., Wei, Y., & Ji, Z. (2025). Construction of a Machining Process Knowledge Graph and Its Application in Process Route Recommendation. Electronics, 14(15), 3156. https://doi.org/10.3390/electronics14153156

Vancouver

Li L, Liang J, Li C, Liu Z, Wei Y, Ji Z. Construction of a Machining Process Knowledge Graph and Its Application in Process Route Recommendation. Electronics. 2025;14(15):3156. doi:10.3390/electronics14153156

BibTeX
@article{Li2025,
  author = {Li, Liang and Liang, Jiaxing and Li, Chunlei and Liu, Zhe and Wei, Yingying and Ji, Zeyu},
  title = {Construction of a Machining Process Knowledge Graph and Its Application in Process Route Recommendation},
  journal = {Electronics},
  year = {2025},
  volume = {14},
  number = {15},
  pages = {3156},
  doi = {10.3390/electronics14153156}
}
Kostenlos starten →