Optimal Allocation and Sizing of BESS Based on a Reliability-Oriented Planning Approach for Transmission Systems
Electricity · 03.11.2026 · 7 (4) · 136
DOI: 10.3390/electricity7040136 ↗Kurz gefasst
Fachartikel in der Zeitschrift Electricity, online erschienen am 03.11.2026. Verfasst von Sergio David Diaz-Perez und 5 weiteren Autor:innen. Die Arbeit nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Planning battery energy storage systems (BESS) in transmission networks requires accounting for the effects of component failures on supply continuity. This paper proposes a reliability-oriented methodology based on a Mixed Gray Wolf Optimizer (MGWO) to determine BESS locations, rated active power capacities, and technology selection between lithium-ion (Li-ion) and vanadium redox flow (VRF) batteries. The framework incorporates stochastic reliability models for transmission lines, transformers, busbars, and BESS units. The objective is to minimize the equally weighted average of annual energy not supplied (ENS) across single-generator-outage scenarios, subject to technical constraints and an investment budget. BESS sizing refers to rated power in MW; energy capacity and chronological state of charge are not explicitly modeled. The methodology is evaluated using the IEEE 39-bus New England test system with representative hourly demand profiles. Under a maximum investment budget of USD 300 million, the selected solution comprises 338.66 MW of installed BESS capacity, including 280.78 MW of Li-ion storage and 57.88 MW of VRF storage, at a total investment of USD 299.87 million. Relative to the reference case, SAIDI and SAIFI decrease by 13.76% and 13.11%, respectively. During optimization, the fitness value decreases from approximately 0.878 to 0.828 p.u., representing an improvement of about 6.5% relative to the initial solution. Ten independent runs yield final fitness values between 0.8213 and 0.8300 p.u. These results demonstrate the framework’s ability to identify feasible BESS configurations that improve reliability under the adopted modeling assumptions.
Zitieren
APA
Diaz-Perez, S. D., Marin-Quintero, J. G., Silva-Ortega, J. I., Gallardo, R. P., Orozco-Henao, C. A., & Herrera-Orozco, A. R. (2026). Optimal Allocation and Sizing of BESS Based on a Reliability-Oriented Planning Approach for Transmission Systems. Electricity, 7(4), 136. https://doi.org/10.3390/electricity7040136
Vancouver
Diaz-Perez SD, Marin-Quintero JG, Silva-Ortega JI, Gallardo RP, Orozco-Henao CA, Herrera-Orozco AR. Optimal Allocation and Sizing of BESS Based on a Reliability-Oriented Planning Approach for Transmission Systems. Electricity. 2026;7(4):136. doi:10.3390/electricity7040136
BibTeX
@article{DiazPerez2026,
author = {Diaz-Perez, Sergio David and Marin-Quintero, Juan Guillermo and Silva-Ortega, Jorge Ivan and Gallardo, Rafael Peña and Orozco-Henao, Cesar Augusto and Herrera-Orozco, Andrés Ricardo},
title = {Optimal Allocation and Sizing of BESS Based on a Reliability-Oriented Planning Approach for Transmission Systems},
journal = {Electricity},
year = {2026},
volume = {7},
number = {4},
pages = {136},
doi = {10.3390/electricity7040136}
}
EUVIMED