Optimization Design and Experimental Study of Solid Particle Spreader for Unmanned Aerial Vehicle
Drones · 01.12.2024 · 8 (12) · 726
DOI: 10.3390/drones8120726 ↗Kurz gefasst
Fachartikel in der Zeitschrift Drones, online erschienen am 01.12.2024. Verfasst von Linhuan Zhang und 6 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Shanghai Chongming Agricultural Science and Technology Innovation Project, Construction project of the international science and technology cooperation platform of BAAFS, Innovation Capacity Construction Project of the BAAFS.
Abstract (Originalsprache)
This study designed and investigated a solid particle spreader, as well as parameter optimization and experimental for a groove wheel, to mitigate the problems of low uniformity and poor control accuracy of solid particulate material UAV spreading. The discrete element method was used to simulate and analyze the displacement range and stability of each grooved wheel at low speeds. Furthermore, orthogonal regression and response surface analyses were used to analyze the influence of each factor on the stability of the discharge rate and pulsation amplitude. The results showed that the helix angle, sharpness, and length of the groove significantly influenced the application performance, whereas the number of grooves had no significant influence. The groove shape was eccentric, the helix angle was 50°, the length was 35 mm, and the number of grooves was 7. Additionally, the bench test results showed that in the range of 10–60 rpm, the relative deviation of the discharging rate between the simulation and bench test is from 0.47% to 10.39%, and the average relative deviation is 3.93%. Between the groove wheel rotation speed and discharge rate, R2 was 0.991, and the adjustable range of the discharge amount was between 3.68 and 23.43 g/s. The minimum and maximum variation coefficients of the average discharge rate among individual applicators were 1.01% and 2.79%, respectively, whereas the standard deviations were 0.09 and 0.46 g/s, respectively. In conclusion, the discharge stability and adjustable range of the spreader using the optimized groove wheel satisfied the requirements for solid particulate material discharge.
Förderung
- Shanghai Chongming Agricultural Science and Technology Innovation Project
- Construction project of the international science and technology cooperation platform of BAAFS
- Innovation Capacity Construction Project of the BAAFS
Zitieren
APA
Zhang, L., Zhang, R., Yi, T., Zhang, D., Ding, C., Wu, M., & Noguchi, R. (2024). Optimization Design and Experimental Study of Solid Particle Spreader for Unmanned Aerial Vehicle. Drones, 8(12), 726. https://doi.org/10.3390/drones8120726
Vancouver
Zhang L, Zhang R, Yi T, Zhang D, Ding C, Wu M, et al. Optimization Design and Experimental Study of Solid Particle Spreader for Unmanned Aerial Vehicle. Drones. 2024;8(12):726. doi:10.3390/drones8120726
BibTeX
@article{Zhang2024,
author = {Zhang, Linhuan and Zhang, Ruirui and Yi, Tongchuan and Zhang, Danzhu and Ding, Chenchen and Wu, Mingqi and Noguchi, Ryozo},
title = {Optimization Design and Experimental Study of Solid Particle Spreader for Unmanned Aerial Vehicle},
journal = {Drones},
year = {2024},
volume = {8},
number = {12},
pages = {726},
doi = {10.3390/drones8120726}
}
EUVIMED