EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Design and Evaluation of a UAV-Attached Multisampling Device for Water Collection

Islam Magomedov, Elah Magomedov, Diego Zelaya, Phuc Hau Nguyen, Artur Bagov, Sergey Valeev, Jose Luis Ordoñez Avila

Designs · 21.05.2026 · 10 (3) · 58

DOI: 10.3390/designs10030058 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Designs, online erschienen am 21.05.2026. Verfasst von Islam Magomedov und 6 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Federal State Budgetary Educational Institution of Higher Education “Kadyrov Chechen State University”.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Unmanned aerial vehicles (UAVs) have emerged as flexible platforms for environmental monitoring, including water sampling in hard-to-reach or hazardous areas. However, most existing UAV-based sampling solutions are limited to single-point collection or rely on complex fluid routing mechanisms that increase the risk of leakage and cross-contamination. This paper presents a novel ribbon-based multisampling capsule that enables sequential water collection from multiple locations during a single UAV deployment. The proposed mechanism employs a motor-driven ribbon with a single movable orifice that is sequentially aligned with individual sampling containers, allowing controlled intake and closure through a combination of hydrostatic pressure and mechanical sealing. A functional prototype was developed and experimentally evaluated to assess sampling feasibility and operational robustness. Experimental results demonstrate that improvements in sealing significantly reduce leakage events and eliminate dispenser-related carry-over, while enabling repeatable multi-point sampling. In addition, exploratory computational fluid dynamics (CFD) simulations were conducted to characterize hydrodynamic loads acting on the capsule and to support future design iterations, rather than to provide fully converged hydrodynamic validation. The proposed solution offers a practical, lightweight, and mechanically simple approach to UAV-assisted multi-point water sampling, with clear potential for further optimization and field deployment.

Förderung

  • Federal State Budgetary Educational Institution of Higher Education “Kadyrov Chechen State University”

Zitieren

APA

Magomedov, I., Magomedov, E., Zelaya, D., Nguyen, P. H., Bagov, A., Valeev, S., & Avila, J. L. O. (2026). Design and Evaluation of a UAV-Attached Multisampling Device for Water Collection. Designs, 10(3), 58. https://doi.org/10.3390/designs10030058

Vancouver

Magomedov I, Magomedov E, Zelaya D, Nguyen PH, Bagov A, Valeev S, et al. Design and Evaluation of a UAV-Attached Multisampling Device for Water Collection. Designs. 2026;10(3):58. doi:10.3390/designs10030058

BibTeX
@article{Magomedov2026,
  author = {Magomedov, Islam and Magomedov, Elah and Zelaya, Diego and Nguyen, Phuc Hau and Bagov, Artur and Valeev, Sergey and Avila, Jose Luis Ordoñez},
  title = {Design and Evaluation of a UAV-Attached Multisampling Device for Water Collection},
  journal = {Designs},
  year = {2026},
  volume = {10},
  number = {3},
  pages = {58},
  doi = {10.3390/designs10030058}
}
Kostenlos starten →