EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Wetting Behavior of Cationic and Anionic Surfactants on Hydrophobic Surfaces: Surface Tension and Contact Angle Measurements

Sujit Kumar Shah, Rojina Bhattarai, Sujata Gautam, Pawan Shah, Ajaya Bhattarai

Colloids and Interfaces · 08.01.2026 · 10 (1) · 8

DOI: 10.3390/colloids10010008 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Colloids and Interfaces, online erschienen am 08.01.2026. Verfasst von Sujit Kumar Shah und 4 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, cationic surfactant cetyltrimethylammonium bromide (CTAB) and anionic surfactant sodium bis(2-ethylhexyl) sulfosuccinate (AOT) are employed to systematically investigate surface and wetting properties on hydrophobic surfaces, specifically in mixed solvents composed of ethylene glycol (EG) and water at 298.15 K. By varying the concentration of each surfactant within the EG–water mixture, both surface tension and contact angle measurements are performed to elucidate how surfactant type and solvent composition influence interfacial behavior and wettability. PTFE and wax surfaces were chosen as model hydrophobic surfaces. Surface tension measurements obtained in pure water and in water–EG mixtures containing 5, 10, and 20 volume percentage EG reveal a consistent decrease in the premicellar slope (dγdlogC) with increasing EG content. This reduction reflects weakened hydrophobic interactions and less effective surfactant adsorption at the air–solution interface. The corresponding decline in maximum surface excess (Γmax) and increase in minimum area per molecule (Amin) confirm looser interfacial packing due to EG participation in the solvation layer. Plots of adhesion tension (AT) versus surface tension (γ) exhibit negative slopes, consistent with reduced solid–liquid interfacial tension (ΓLG) and greater redistribution of surfactant molecules toward the solid–liquid interface. AOT shows stronger sensitivity to EG compared to CTAB, reflecting structural headgroup-specific adsorption behavior. Work of adhesion (WA) measurements demonstrate enhanced wettability at higher EG concentrations, highlighting the cooperative impact of co-solvent environment and surfactant type on wetting phenomena.

Zitieren

APA

Shah, S. K., Bhattarai, R., Gautam, S., Shah, P., & Bhattarai, A. (2026). Wetting Behavior of Cationic and Anionic Surfactants on Hydrophobic Surfaces: Surface Tension and Contact Angle Measurements. Colloids and Interfaces, 10(1), 8. https://doi.org/10.3390/colloids10010008

Vancouver

Shah SK, Bhattarai R, Gautam S, Shah P, Bhattarai A. Wetting Behavior of Cationic and Anionic Surfactants on Hydrophobic Surfaces: Surface Tension and Contact Angle Measurements. Colloids and Interfaces. 2026;10(1):8. doi:10.3390/colloids10010008

BibTeX
@article{Shah2026,
  author = {Shah, Sujit Kumar and Bhattarai, Rojina and Gautam, Sujata and Shah, Pawan and Bhattarai, Ajaya},
  title = {Wetting Behavior of Cationic and Anionic Surfactants on Hydrophobic Surfaces: Surface Tension and Contact Angle Measurements},
  journal = {Colloids and Interfaces},
  year = {2026},
  volume = {10},
  number = {1},
  pages = {8},
  doi = {10.3390/colloids10010008}
}
Kostenlos starten →