Cutting Performance of SiAlON Ceramic End Mills in the High-Speed Milling of Inconel 718
Coatings · 25.10.2026 · 16 (11) · 1272
DOI: 10.3390/coatings16111272 ↗Kurz gefasst
Fachartikel in der Zeitschrift Coatings, online erschienen am 25.10.2026. Verfasst von Mengchao Fan und 5 weiteren Autor:innen. Die Arbeit nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
To investigate the effect of spindle speed on the cutting response of solid SiAlON ceramic end mills during dry milling of Inconel 718, down-milling tests were conducted at 14,000, 16,000, and 18,000 r/min with identical nominal tool geometry, feed per tooth, and axial and radial depths of cut. Each tool completed a cumulative effective cutting length of 5 m. Cutting forces, temperature, and tool and chip morphologies were analyzed. Increasing the spindle speed from 14,000 to 16,000 r/min reduced the mean x-direction force by 10.7%, whereas the mean y- and z-direction forces increased. A further increase to 18,000 r/min raised the theoretical material removal rate by 12.5% but increased the mean z-direction force by 105.4%, relative to 16,000 r/min. The proportion of the recorded time above 900 °C reached 52.3%, accompanied by an increase in the mean resultant force during the middle and later stages of machining and more pronounced morphological irregularities at the end cutting edges. In contrast, at 16,000 r/min, the mean resultant force varied relatively little during these stages, and the end cutting-edge profiles remained relatively well defined. These findings indicate that, under the tested conditions, the productivity gains from increasing spindle speed should be evaluated jointly with multidirectional cutting loads, thermal conditions, and tool damage.
Zitieren
APA
Fan, M., Lu, W., Cai, Y., Tang, X., Wei, J., & Zhang, A. (2026). Cutting Performance of SiAlON Ceramic End Mills in the High-Speed Milling of Inconel 718. Coatings, 16(11), 1272. https://doi.org/10.3390/coatings16111272
Vancouver
Fan M, Lu W, Cai Y, Tang X, Wei J, Zhang A. Cutting Performance of SiAlON Ceramic End Mills in the High-Speed Milling of Inconel 718. Coatings. 2026;16(11):1272. doi:10.3390/coatings16111272
BibTeX
@article{Fan2026,
author = {Fan, Mengchao and Lu, Wuchang and Cai, Yuan and Tang, Xiaozhuang and Wei, Jiaxuan and Zhang, Anshan},
title = {Cutting Performance of SiAlON Ceramic End Mills in the High-Speed Milling of Inconel 718},
journal = {Coatings},
year = {2026},
volume = {16},
number = {11},
pages = {1272},
doi = {10.3390/coatings16111272}
}
EUVIMED