Development of Piezoelectric Thin-Film Ultrasonic Transducers for Wind Turbine Bolt Preload Measurement
Coatings · 25.06.2026 · 16 (7) · 750
DOI: 10.3390/coatings16070750 ↗Kurz gefasst
Fachartikel in der Zeitschrift Coatings, online erschienen am 25.06.2026. Verfasst von Yan Li und 11 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: China Energy Science and Technology Research Institute Co., Ltd..
Abstract (Originalsprache)
The detection of bolt preload force is of vital importance for ensuring the structural reliability of equipment under extreme operating conditions. Traditional ultrasonic transducers based on bulk piezoelectric materials suffer from poor long-term coupling stability and high brittleness of the material, which limits their practical applications. In this work, AlN piezoelectric thin films were fabricated by RF magnetron sputtering, and the effects of RF power and target-to-substrate distance on film morphology, crystal structure, and ultrasonic response were investigated. The results show that increasing RF power increased the film thickness and deposition rate, reduced the detected O content on the film surface, and changed the XRD response. The film deposited at 900 W generated ultrasonic longitudinal wave echoes with a relatively high signal amplitude among the tested RF powers. Among the tested target-to-substrate distances, the film deposited at 60 mm showed a relatively higher deposition rate and generated an ultrasonic longitudinal wave echo with a relatively higher amplitude. The measured d33 value of this film was approximately 4.8 pC/N. The AlN thin-film ultrasonic transducers prepared under the selected deposition conditions were directly deposited on bolts, and the effects of temperature and axial load were calibrated using the ultrasonic TOF measurement method. There was a linear correlation between the TOF and the temperature (R2 > 99.99%), as well as between the TOF and the axial load. These results indicate that the deposited AlN thin-film transducer has potential for bolt preload measurement in wind turbine bolts.
Förderung
- China Energy Science and Technology Research Institute Co., Ltd.
Zitieren
APA
Li, Y., Jiang, Y., Du, B., Zhang, Y., Chang, W., Wei, R., Ren, B., Chang, Q., Wang, B., Li, Y., Zhang, J., & Yang, B. (2026). Development of Piezoelectric Thin-Film Ultrasonic Transducers for Wind Turbine Bolt Preload Measurement. Coatings, 16(7), 750. https://doi.org/10.3390/coatings16070750
Vancouver
Li Y, Jiang Y, Du B, Zhang Y, Chang W, Wei R, et al. Development of Piezoelectric Thin-Film Ultrasonic Transducers for Wind Turbine Bolt Preload Measurement. Coatings. 2026;16(7):750. doi:10.3390/coatings16070750
BibTeX
@article{Li2026,
author = {Li, Yan and Jiang, Yanghui and Du, Baocang and Zhang, Ye and Chang, Wei and Wei, Ran and Ren, Bingbing and Chang, Qingdong and Wang, Bin and Li, Yaqian and Zhang, Jun and Yang, Bing},
title = {Development of Piezoelectric Thin-Film Ultrasonic Transducers for Wind Turbine Bolt Preload Measurement},
journal = {Coatings},
year = {2026},
volume = {16},
number = {7},
pages = {750},
doi = {10.3390/coatings16070750}
}
EUVIMED