EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Process Optimization and Microstructural Evolution of TC4 Alloy with YH2 Addition Fabricated by PBF-LB

Wei Zhang, Baozhen Yang, En Zhu, Feibiao Yu

Coatings · 02.05.2026 · 16 (5) · 543

DOI: 10.3390/coatings16050543 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 02.05.2026. Verfasst von Wei Zhang und 3 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Key Laboratory of Xinjiang Uygur Autonomous Region, China, Excellent Postdoctoral General Fund Project of Xinjiang Uygur Autonomous Region, Tianchi Talent Introduction Program of Xinjiang Uygur Autonomous Region.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A three-factor, four-level orthogonal design was employed to optimize the overall forming quality of powder bed fusion with a laser beam (PBF-LB)-fabricated TC4 alloy containing 0.3 wt.% YH2. Sixteen process-parameter combinations were established, and two specimens were fabricated for each combination. Laser power, scanning speed, and hatch spacing were selected as the investigated variables. Relative density, surface roughness, and Vickers hardness were evaluated using the entropy weight method combined with the weighted-sum method. On this basis, the microstructure of the specimens produced under the optimal process parameters was systematically characterized. The results showed that the influence of the investigated factors on overall forming quality followed the order: hatch spacing > laser power > scanning speed. The optimal process parameters were a laser power of 200 W, a scanning speed of 1100 mm/s, and a hatch spacing of 0.10 mm, under which the specimens exhibited superior overall forming quality. The addition of 0.3 wt.% YH2 did not significantly alter the dominant phase constitution of the alloy, but promoted α′ martensite refinement and weakened the texture through the in situ formation of Y2O3 nano-oxide particles.

Förderung

  • Key Laboratory of Xinjiang Uygur Autonomous Region, China
  • Excellent Postdoctoral General Fund Project of Xinjiang Uygur Autonomous Region
  • Tianchi Talent Introduction Program of Xinjiang Uygur Autonomous Region

Zitieren

APA

Zhang, W., Yang, B., Zhu, E., & Yu, F. (2026). Process Optimization and Microstructural Evolution of TC4 Alloy with YH2 Addition Fabricated by PBF-LB. Coatings, 16(5), 543. https://doi.org/10.3390/coatings16050543

Vancouver

Zhang W, Yang B, Zhu E, Yu F. Process Optimization and Microstructural Evolution of TC4 Alloy with YH2 Addition Fabricated by PBF-LB. Coatings. 2026;16(5):543. doi:10.3390/coatings16050543

BibTeX
@article{Zhang2026,
  author = {Zhang, Wei and Yang, Baozhen and Zhu, En and Yu, Feibiao},
  title = {Process Optimization and Microstructural Evolution of TC4 Alloy with YH2 Addition Fabricated by PBF-LB},
  journal = {Coatings},
  year = {2026},
  volume = {16},
  number = {5},
  pages = {543},
  doi = {10.3390/coatings16050543}
}
Kostenlos starten →