Research on Chemical Agglomeration Technology of Wet Electrostatic Precipitator for Deep Purification of Blast Furnace Gas
Coatings · 27.03.2026 · 16 (4) · 405
DOI: 10.3390/coatings16040405 ↗Kurz gefasst
Fachartikel in der Zeitschrift Coatings, online erschienen am 27.03.2026. Verfasst von Shuting Wang und 4 weiteren Autor:innen. Die Arbeit nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Hebei Provincial Department of Science and Technology, Qinhuangdao Science and Technology Bureau.
Abstract (Originalsprache)
To prevent fouling in blast furnace gas top pressure recovery turbine units, the dust content of the gas must be reduced, necessitating its deep purification. A critical challenge to be addressed is the low collection efficiency of fine particulate matter. To improve the collection efficiency of the fine particulate dust in BFG by wet electrostatic precipitators (WESPs), this study implemented measures such as optimizing nozzle atomization performance and the spatial distribution of droplets, along with adding chemical agglomeration agents and surfactants. These approaches promoted the chemical agglomeration of fine dust and enhanced dust collection efficiency. In this study, five nozzle types, six chemical agglomerating agents, and three surfactants were tested. The results show that, under overlapping spray conditions, the 1/8 solid cone nozzle produced the smallest droplet size with the most uniform spatial distribution, exhibiting a d50 of 141.17 μm. When this nozzle was used in combination with guar gum (GG) as a chemical agglomerant, the d50 of BFG dust increased from 8.46 μm to 14.75 μm. The synergistic application of 5 mg/m3 sesbania gum (SBG) and 5 mg/m3 octylphenol ethoxylate (OP-10) further increased the dust d50 to 19.08 μm. Using the 1/8 solid cone nozzle and an XTG concentration of 5 mg/m3 resulted in the highest dust collection efficiency of 96.76%, while the synergistic use of SBG/OP-10 achieved an efficiency of 97.69%. This study elucidates the influence of nozzle atomization characteristics and spray liquid type on dust agglomeration and collection efficiency, achieving an improvement in dust-removal efficiency and the capture of fine-particulate dust, and providing both theoretical and practical foundations for the deep purification of blast furnace gas.
Förderung
- Hebei Provincial Department of Science and Technology
- Qinhuangdao Science and Technology Bureau
Zitieren
APA
Wang, S., Ren, G., Ma, S., Li, H., & Xiao, L. (2026). Research on Chemical Agglomeration Technology of Wet Electrostatic Precipitator for Deep Purification of Blast Furnace Gas. Coatings, 16(4), 405. https://doi.org/10.3390/coatings16040405
Vancouver
Wang S, Ren G, Ma S, Li H, Xiao L. Research on Chemical Agglomeration Technology of Wet Electrostatic Precipitator for Deep Purification of Blast Furnace Gas. Coatings. 2026;16(4):405. doi:10.3390/coatings16040405
BibTeX
@article{Wang2026,
author = {Wang, Shuting and Ren, Gaijuan and Ma, Siyu and Li, Hengtian and Xiao, Lichun},
title = {Research on Chemical Agglomeration Technology of Wet Electrostatic Precipitator for Deep Purification of Blast Furnace Gas},
journal = {Coatings},
year = {2026},
volume = {16},
number = {4},
pages = {405},
doi = {10.3390/coatings16040405}
}
EUVIMED